User manual ACER VERITON S2611G

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ACER VERITON S2611G. We hope that this ACER VERITON S2611G user guide will be useful to you.


ACER VERITON S2611G : Download the complete user guide (12053 Ko)

Manual abstract: user guide ACER VERITON S2611G

Detailed instructions for use are in the User's Guide.

[. . . ] Each port on the GS605/GS608 switch automatically configures itself correctly when you plug in a device’s cable. Installation guide, Warranty/ Support information card Vertical stand Power adapter When you open the box, verify that you received everything. 2 • • Prepare to Install the Switch Decide where you want to place the switch. find a flat horizontal surface — such as a table , desk or shelf. [. . . ] Make sure the selected location is: Not in direct sunlight or near a heater or heating vent. There should be at least 2 inches (5 cm) of clear space on all sides of the switch. 1 2 • Well ventilated (especially if it is in a closet). Note: Neither the GS605 nor GS608 are designed to be stacked on top of other GS605 or GS608 switches. If you need several units in one location, use the vertical stand to position several units near each other. Also, you’ll need one Enhanced Category 5 (Cat 5e) Ethernet cable with RJ-45 connectors for each device you want to connect to the switch. Note: If you have more than 5 or 8 devices to connect to this switch, you must connect them to a hub or other switch and then connect that hub or switch to this switch. See the note about placing several switches near each other in section 2. Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip). Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations. Network Interface: DC Power: Physical Dimensions (h x w x d): Weight: Operating Temperature: Electromagnetic Compliance: Safety Agency Approvals for the Power Adapter: Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference. € This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. € Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Performance Specifications Frame Filter Rate: Frame Forward Rate: Network Latency: (using 64-byte packets) Address Database Size: Addressing: Packet Buffer Memory: 14, 800 frames/sec max for 10M port/148, 800 frames/sec max for 100M port/1, 488, 000 frames/sec max for 1000M port 14, 800 frames/sec max for 10M port / 148, 800 frames/sec max for 100M port/1, 488, 000 frames/sec max for 1000M port 1000 Mbps to 1000 Mbps: 20 µs max 4000 MAC addresses 48-bit MAC address 1 Mb EN 55 022 Declaration of Conformance This is to certify that the ACER Model GS605/608 Gigabit Ethernet Switch is shielded against the generation of radio interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ACER VERITON S2611G




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ACER VERITON S2611G will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.