User manual AIRWELL RC4 900087

[. . . ] If you want to change the control settings, proceed according to the following instructions. Otherwise, the air conditioner will start and operate in the same mode and functions prior to being turned off. VENTILATING OPERATION Select the ventilating mode by pressing MODE button (2). Switch to the desired fan speed by pressing FAN speed button (4). COOLING OPERATION Select the COOLING mode by pressing MODE button (2). [. . . ] Prevent the I FEEL sensor from being affected by heat sources such as lamps, heaters, direct sun, etc. These may cause the sensor to transmit the Wrong temperature data, thereby disturbing the performance of the I FEEL function. By pressing on ROOM temperature, the measured room temperature and the room temperature sign will be displayed. To cancel the ROOM Temperature display press on one of the following: Press again on ROOM temperature button (3). Change of MODE button (2) Note: Room temperature range is between 6 and 36 in 1 increments. Display should show "HI" or "LO" to represent temperature that is above 36 or below 6 . SLEEP FUNCTION Press the SLEEP button (6) to select the SLEEP function. The sleep icon light while the sleep OFF time icon and the time which is 7 hours after current time blink as default. (The sleep timer will display the default time or the setting time plus the current time initially in the display). For example: current time is 23:00 and the sleep mode is set, the sleep mode OFF time will be 6:00. If the sleep off time is set to 10 hr, the sleep mode OFF time will be 9:00. All other timers will temporarily be suspended during the activation of the sleep timer. To cancel the SLEEP function press one of the following: START/STOP button (1) SLEEP button (6) NOTE: In some models the SLEEP icon lights only and the OFF time is set for seven hours as default. 3 TIMER OPERATION There are four timers that can be selected on the remote control. Two daily timers (designated as T1, T2), and two optional weekend timers (designated as WKTI, WKT2). Each timer can be selected by pressing TIMER button (11). To set each timer use time adjust up and down buttons Hour+(18) and Hour-(19) respectively. [. . . ] Press CLEAR button. 1 The selected timer icon blinks & the corre spending previous time ON, OFF settings light. All settings of the selected timer are cleared. NOTES: 1. The default settings for the timers are 7:00 and 18:00, for ON and OFF respectively. 2. The timer mode will always display the last ON and OFF settings on the LCD display. 3. Pressing CLEAR button (12) for 5 seconds will cancel all timer settings and clear timer display. 7 AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT Press button (7) to activate the supply air flap to auto swing; Press button (8) to activate the Horizontal Air Flow to auto swing. [. . . ]