User manual ALCATEL XS

[. . . ] Remark: If no number has been preset, 2 beep tones are emitted indicating the memory is empty. Adjust Ringer Volume You can select the ringer volume in standby mode or in phone setting mode or in ringing mode by pressing key and key during ringing phase. There are 6 levels (level 1 to 5 and off) Package contents: The package contains the following items: 1. [. . . ] Example for programming the Memory M1 or M2 or M3: DC plug from AC adaptor 2. 2 Installing and charging the batteries 1) Slide down to open the battery compartment cover. 4) Put the handset on the base and charge for 24 hours before using the handset for the first time. The handset will give a beep when it is properly placed on the charger. The LED is lighted up in Red and the handset will give a beep. Remove the film before use When the communication mode is set up, press key on the keypad of your mobile phone. Press 2 digits (0 and 1) for programming the Memory 1 or digit (0 and 2) for the memory 2 or digit (0 and 3) for the memory 3. Then enter the number from the keypad of your mobile phone to edit the memory number. Terminates by key #, a long beep confirmation tone is emitted to confirm the programming. In case of mistake in the entry, you can always terminate the ongoing command by entering key # and resume with key without releasing the communication mode. In case of error in the command a double beep error tone is emitted after entering key #. In that case, resume the command by entering key . Notes: 1) Use only the supplied NiMH rechargeable batteries. 2) If the handset will not be used for a long time, disconnect and remove the batteries to prevent possible leakage. During the preset of the Ringer volume and Melody, the Melody is played back after entering the digit 1 to 5. key again to disconnect Alcatel XS from the communication mode after you TABLE 1: PROGRAMMING SETTING Menu name Ringer volume control Ringtones on handset Quick dial Quick dial Quick dial Default settings Registration to be described in Section 4. 1 Pin Code Number Action Ring volume control Choose ringer melody Program M1 Program M2 Program M3 Secuencia en el teclado alfanumérico press " 05" + " "value" +"#" (complete by hearing a confirmation tone); value = 0 to 5 Wait the end of the melody for selecting another volume. press " 04" + " "value" +"#" (complete by hearing a confirmation tone); value = 1 to 5 Wait the end of the melody for selecting another volume. press " 01" + "number(20 digits in length)" + "#" (complete by hearing a confirmation tone ) press " 02" + "number(20 digits in length)" + "#" (complete by hearing a confirmation tone ) press " 03" + "number(20 digits in length)" + "#" (complete by hearing a confirmation tone ) SAFETY In the event of an electrical hazard, the mains adapter acts as 230V power isolating device. It should therefore, as a precaution, be installed close to the appliance and be easily accessible. To disconnect the device from the primary power source, the mains adapter must be removed from the 230V AC / 50 Hz socket. If the mains adapter fails, it must be replaced by an identical model. If not connected to the mains power or if there is a mains power failure, telephones that use cordless handsets will not work. [. . . ] The advantages include not only very low electricity consumption, but also a more compact format than the conventional power supply units used by the previous range. The used batteries from your telephone (if it has batteries) must be disposed of in compliance with current environmental protection regulations. Check that the telephone line cord has been plugged into the base station and the phone socket. [. . . ]