User manual AQUA-TRONICS LOADED LINE DETECTOR AT-9

[. . . ] lICENSES / OPEN SOURCE SOFTWARE NOTICE 3 LICENSES Supported licenses may differ by model. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories. ENGLISH ENG HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. aBOUT DIVX VIDEO: DivX® is a digital video format created by DivX , LLC , a subsidiary of Rovi Corporation. [. . . ] ENGLISH ENG CAUTION y Avoid touching the screen at all times, as this may result in damage to the screen. Y It is recommended to move the TV in the box or packing material that the TV originally came in. Y Before moving or lifting the TV, disconnect the power cord and all cables. Y When holding the TV, the screen should face away from you to avoid damage. Y When transporting the TV, do not expose the TV to jolts or excessive vibration. Y When transporting the TV, keep the TV upright, never turn the TV on its side or tilt towards the left or right. Y Whenever you handle TV, Protection pad should be covered with side of TV. (Depending on model) Protection Pad y Hold the top and bottom of the TV frame ¿rmly. Make sure not to hold the transparent part, speaker, or speaker grill area. 18 ASSEMBLING AND PREPARING Mounting on a table 1 Lift and tilt the TV into its upright position on a table. Securing the TV to a table Fix the TV to a table to prevent from tilting forward, damage, and potential injury. Y Do not over tighten the screws as this may cause damage to the TV and void your warranty. Any damages or injuries by misuse or using an improper accessory are not covered by the warranty. 10 cm 10 cm 10 cm 10 cm Make sure to use screws and wall mount bracket that meet the VESA standard. Standard dimensions for the wall mount kits are described in the following table. Separate purchase(Wall Mounting Bracket) Model 32/37LS57** 32/37LM62** 32LM64** 32LM66** 200 x 200 M6 4 LSW200BX 42LS57** 42/47/55LM62** 42/47/55/60LM64** 42/47/55LM66** 42/47/55LM67** 42/47/55LM76** 400 x 400 M6 4 LSW400BX NOTE y Use the screws that are listed on the VESA standard screw specifications. Y The wall mount kit includes an installation manual and necessary parts. Y For more information, refer to the manual supplied with the wall mount. Y When attaching a third-party wall mounting bracket to the TV, insert the wall mount inner spacers into the TV wall mount holes to move your TV in vertical angle. Please make sure not to use the spacers for AQUA-TRONICS wall mounting bracket. (Only 32/37/42LS57**, 32/37/42/47/55LM62**) VESA (A x B) Standard screw Number of screws Wall mount bracket LSW220BX LSW420BX Model VESA (A x B) Standard screw Number of screws Wall mount bracket 65LM62** 600 x 400 M8 4 LSW600B LSW620B A B Wall Mount Inner Spacer (Depending on model) y In order to protect the TV screen(scratch, fingerprint), put TV on flat table without removing wrapping bag. Y After removing the wrapping bag on the back of the TV, install TV according to manual included in wall mounting bracket product. [. . . ] Connect the external device and the TV with the headphone as shown on the following illustration. When changing AV MODE with a headphone y connected, the change is applied to video but not to audio. Optical Digital Audio Out is not available y when connecting a headphone. ) AV1 AUDIO / VIDEO English Transmits the video and audio signals from an external device to the TV set. [. . . ]