User manual ASROCK A770CROSSFIRE

[. . . ] No part of this installation guide may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc. Products and corporate names appearing in this guide may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. Specifications and information contained in this guide are furnished for informational use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this guide. [. . . ] (CrossFireTM Bridge is provided with the graphics card you purchase, not bundled with this motherboard. (You may use the DVI to D-Sub adapter to convert the DVI connector to D-Sub interface, and then connect the D-Sub monitor cable to the DVI to D-Sub adapter. Remove the ATITM driver if you have any VGA driver installed in your system. We recommend using this utility to uninstall any previously installed Catalyst drivers prior to installation. ATITM recommends Windows® XP Service Pack 2 or higher to be installed (If you have Windows® XP Service Pack 2 or higher installed in your system, there is no need to download it again): http://www. Install the VGA card drivers to your system, and restart your computer. Then you will find "ATI Catalyst Control Center" on your Windows® taskbar. Although you have selected the option "Enable CrossFireTM", the CrossFireTM function may not work actually. After restarting your computer, please confirm whether the option "Enable CrossFireTM" in "ATI Catalyst Control Center" is selected or not; if not, please select it again, and then you are able to enjoy the benefit of CrossFireTM feature. , and is used only for identification or explanation and to the owners' benefit, without intent to infringe. With the external add-on PCI Express VGA cards, you can easily enjoy the benefits of Surround Display feature. The illustration shows a 3-pin jumper whose pin1 and pin2 are "Short" when jumper cap is placed on these 2 pins. Short pin2, pin3 to enable +5VSB (standby) for PS/2 or USB wake up events. Note: To select +5VSB, it requires 2 Amp and higher standby current provided by power supply. the data in CMOS includes system setup information such as system password , date , time , and system setup parameters. To clear and reset the system parameters to default setup, please turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clearCMOS action. Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. These six Serial ATAII (SATAII) connectors support SATAII or SATA hard disk for internal storage devices. SATAII_6 connector can be used for internal storage device or be connected to eSATAII connector to support eSATAII device. [. . . ] sTEP 3: Install Windows® XP / Windows® XP 64-bit OS on your system. After step 1, 2, you can start to install Windows® XP / Windows® XP 64-bit OS on your system. If you want to install Windows® VistaTM or Windows® VistaTM 64-bit on your SATA / SATAII HDDs without RAID functions, please follow below steps. Using SATA / SATAII HDDs and eSATAII devices with NCQ and Hot Plug functions STEP 1: Set Up BIOS. [. . . ]