User manual ASROCK FM2A75M-DGS R2.0

[. . . ] LAN Port LED Indications Status SPEED LED Description Activity/Link LED Status Description ACT/LINK SPEED LED LED Off No Link Blinking Data Activity On Link Off Orange Green 10Mbps connection 100Mbps connection 1Gbps connection LAN Port ** To enable Multi-Streaming function, you need to connect a front panel audio cable to the front panel audio header. Please refer to below steps for the software setting of Multi-Streaming. After restarting your computer, please double-click “Realtek HD Audio Manager” on the system tray. set “Speaker Configuration” to “Quadraphonic” or “Stereo”. [. . . ] To clear and reset the system parameters to default setup, please turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clear-CMOS action. Please be noted that the password, date, time, user default profile, 1394 GUID and MAC address will be cleared only if the CMOS battery is removed. Please adjust the BIOS option “Clear Status” to clear the record of previous chassis intrusion status. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!15) SATA_5 SATA_6 These six Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. SATA_1 SATA_2 SATA_3 Serial ATA (SATA) Data Cable (Optional) SATA_4 Either end of the SATA data cable can be connected to the SATA3 hard disk or the SATA3 connector on this motherboard. 23) This is an interface for the front panel audio cable that allows convenient connection and control of audio devices. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instruction in our manual and chassis manual to install your system. If you use AC’97 audio panel, please install it to the front panel audio header as below: A. You don’t need to connect them for AC’97 audio panel. For Windows® 8 / 8 64-bit / 7 / 7 64-bit / VistaTM / VistaTM 64-bit OS: Go to the "FrontMic" Tab in the Realtek Control panel. 28) This motherboard supports CASE OPEN detection feature that detects if the chassis cover has been removed. This feature requires a chassis with chassis intrusion detection design. 0 Motherboard 11 English System Panel Header (9-pin PANEL1) This header accommodates several system front panel (see p. Connect the power switch, reset switch and system status indicator on the chassis to this header according to the pin assignments below. PWRBTN (Power Switch): Connect to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch. RESET (Reset Switch): Connect to the reset switch on the chassis front panel. [. . . ] And then key in drvcfg –s [Drv number] [Ctrl number] to enter Raid Utility. If you install Windows® 8 64-bit / 7 64-bit / VistaTM 64-bit in a large hard disk (ex. Disk volume > 2TB), it may take more time to boot into Windows® or install driver/utilities. If you encounter this problem, you will need to following instructions to fix this problem. [. . . ]