User manual AT&T 2402

[. . . ] 2402_map_2ATT 5/7/02 6:32 PM Page 6 REVISED 5/7/02 USER'S MANUAL Part 2 Expansion Handset 2402 Fold open this manual for information about this product's installation and operation. Please also read Part 1 -- Important Product Information. © 2001 Advanced American Telephones. [. . . ] Press and hold O (CLEAR) to return to the idle screen. · · Softkeys Screen display of operations to be selected with softkeys. 1 2402_map_2ATT 5/7/02 6:32 PM Page 2 C H A R G E T H E B AT T E R Y 1 Install the handset battery pack. Use only the battery supplied with this handset or AT&T Accessory Battery Model 2401, SKU#91077. a) Remove battery compartment cover by pressing on indentation and sliding downward. c) Replace cover by sliding it on its track up over battery case until it snaps firmly into place. b) Place the battery pack in the handset. Match the metal contacts on the battery with the contacts in the battery compartment. · 2 When you install the battery pack the first time, the handset will display ENTER BASE ID. Charge the handset battery. · Place the handset in the remote charging stand (purchased separately). After the first charge, the battery typically charges in only eight hours. 2 2402_map_2ATT 5/7/02 6:32 PM Page 3 REGISTER THE HANDSET 1 2 3 4 Make sure to charge the handset battery pack at least 12 hours. At the 2462 corded base, press Use or MENU . to select DISPLAY BASE-ID. OK . The base screen will display the 15-digit Base ID code Press for about 30 seconds, then return to the idle screen. Write down the Base ID code so you can enter it at the handset in STEP 6 below. 5 6 7 8 At the cordless handset, use the softkey to select REGISTER. If the handset displays BASE BUSY TRY LATER, the base is in use. For complete operation instructions, refer to the manual that came with your original handset. 3 2402_map_2ATT 5/7/02 6:32 PM Page 4 I N S TA L L AT I O N Belt Clip Attach the belt clip (optional). a) Slide down into grooves to attach. b) To remove, lift one side with your thumbnail and push back. Headset You can use this telephone hands-free when you install any industry standard 2. 5 mm headset (purchased separately). Plug the headset into the jack located on the left side of the handset (under the small rubber flap). Do not force the connection, but make sure the plug fits securely. 4 2402_map_2ATT 5/7/02 6:32 PM Page 5 Battery Life Battery life depends on how far the handset is from the base, and other environmental conditions. [. . . ] If you repeatedly get a Low Battery indicator, even after eight hours of charging, the battery should be replaced. CAUTION: Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in the User's Manual, Part 1. · · · 5 [. . . ]