User manual AT&T 7235

[. . . ] Hold the base so that the mounting knobs on the standard wall jack will fit into the holes on the bottom of the base. Charge the handset batteries at least 10 hours before using the phone. The CHARGING light on the base goes on to show the handset is in the right position to charge the batteries. After the batteries are charged, pick up the handset and extend the base antenna. [. . . ] NOTE: You may choose to store emergency numbers in the memory locations. The manufacturer assumes no responsibility for customer reliance upon this memory feature. Memory Guard The phone numbers you store in memory are protected from loss when you change the handset battery, or in the event of a power failure. Directory Label There is a directory label that you can use to keep a record of names or telephone numbers of the numbers stored in memory locations. You can place this label on the handset or the base. Storing a Pause In a Memory Dial Number When storing a number in memory, press and hold down the number button that comes before the pause, until you hear the second beep. If you hold the number button down longer, you will hear more beeps as additional pauses are stored. For example, to store 9, PAUSE, 555-1234 in memory location 3: Press p, 9, (hold the 9 for 2 seconds, until a second beep is heard. ) Then press 5 5 5 1 2 3 4 p 3. Dialing Speed-Dial Numbers 1 2 3 Press P. Press the number button (0-9) you assigned to the number you're calling. For example, to dial the number stored in location 9, press P, p, 9. Storing Numbers Just Dialed Whenever you make a telephone call, you can store the number you dialed in memory. Press R instead of entering the telephone number when storing speed-dial numbers. 4 BATTERIES Charging the Handset Battery Pack The batteries need charging when: · The phone beeps four times when you press P. · The phone does not respond when you press P, and no lights go on. When the LOW BATTERY light goes on, place the handset flat in the base. NOTE: The handset must lie flat in the base, with the keypad facing down, when charging. A fully charged battery, under normal use, maintains standby power for up to 12 days when the Handset Ringer Control switch is set to ON, and up to 20 days when the Handset Ringer Control switch is set to OFF. If it's more convenient for you, you can leave the handset in the base all the time. If you get a low battery indicator even after 10 hours of charging, the battery should be replaced. CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully. Replacing the Handset Battery Pack 1 Remove the battery case cover on the handset by pressing on the indentation and sliding the cover downward. Place the battery pack into the case, so the wires rest above the battery pack. Replace the cover by sliding it on its track up over the battery case until it snaps firmly into place. Place the handset face down in the base and allow it to charge for 10 hours. The telephone might operate before that, but for best performance, let the handset batteries charge fully. 2 3 4 5 · · · Use Replacement Battery 4051 in the handset. Released electrolyte is corrosive and might cause damage to the eyes or skin. It might be toxic if swallowed. 5 IN CASE OF DIFFICULTY problem is probably in your wiring or local service. Call your local telephone service company. If you have difficulty operating this phone, try the suggestions below. If you still have trouble, call 1 800 722-9125. Noise or Interference · · You may be out of range. [. . . ] To reset the security code, try the following: · Place the handset in the base, and check to make sure the CHARGING light is on. · Place the handset in the base, and check to make sure the CHARGING light is on. Unplug the AC adapter from the outlet, wait 15 seconds, then plug it in again. · Pick up the handset, open the battery compartment, and unplug the battery pack. [. . . ]