User manual AUSTRALIAN MONITOR ATC5488

[. . . ] ATC5488, Tone Generator Module Installation Instructions Thank you for choosing an Australian Monitor Installation Series ATC5488 tone generator module. [. . . ] Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable. For installation into an SA series amplifier: Locate the empty 7 pin `end' connector receptacle on the mixer PCB between the Ch 6 pot and the bass pot. Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable when viewed from the front panel For installation into a TX6000 or TX8000 mixer: Locate the empty 7 pin `end' connector receptacle behind the Ch 5 pot on the mixer PCB. Connect the module to this receptacle, ensuring that the orange wire on the connector is at the right hand end of the connector receptable when viewed from the front panel. The ATC5488 module is supplied with double sided adhesive enabling the module to be permanently attached to the chassis or under the lid of your mixer or amplifier. On selected mixers and amplifiers, spare screw terminals on the rear panel provide a facility where the activation wires from the ATC5488 can be connected to the back panel for easy external connection to switches or a timer. Connections Connection to amplifier: Orange - Output Black - Ground Blue - Mute switch to 1 Red - DC Supply (Min. 18VDC) Connections to activate tones: Black - Common White - Evacuation tone Yellow - Bell Tone Purple - Alert Tone Blue - Pre Announce Chime NOTE: Note that the trim pot located in position R10 on the ATC5488 module attenuates the level out of the ATC5488 and works in an anti-clockwise fashion ie, turning it fully clockwise will completely attenuate the signal output whilst turning it fully anti-clockwise will allow full signal though to the amplifier stage. Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia A. B. N. 78 001 345 482 Inc in NSW www. audiotelex. com. au Export Sales & Corporate Head Office Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Australia Ph: 61-2- 9647 1411 Fax: 61-2-9748 2537 E-mail: ho@audiotelex. com. au Sydney (NSW & ACT Sales) Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Ph: (02) 9647 1411 Fax: (02) 9648 3698 E-mail: nsw@audiotelex. com. au Adelaide (SA & NT Sales) P. O. [. . . ] Box 512, Albany 1331 Unit B, 11 Piermark Drive, Albany 1331 Ph: (09) 415 9426 Fax: (09) 415 9894 E-mail: audiotlx@nznet. gen. nz [. . . ]