User manual BECKER DTM HIGH SPEED 7910 / 7913 INSTALLATION GUIDE

[. . . ] 34 Connecting the speed signal (GAL) for the speedometer / speedometer cable . Prior to installation Before starting installation, please read this installation guide carefully. In particular, please pay attention to the safety and installation instructions. Subject to correction and technical modifications 28 Copyright by Becker GmbH, D-76303 Karlsbad Installation guide 2. Symbols used in the installation guide G denotes instructions which are important for your safety and the safety of others. [. . . ] When pressing in, ensure that the dog is securely positioned and that it runs smoothly. · Pull the hose sleeve and nut as far as possible in the direction of the dog, to achieve approx. Screw the connecting piece and the speed sensor into the cable (Figure 12). Information on the GPS reception is given in the right-hand part of the display. Four different messages may appear: - : GPS reception is already available. - " : If this message is displayed, please contact the hotline. VVV 7, , + 09, *;065 P P P VMN 7, , + 09, *;065 P $! 09, *;065 " 7, , + VMN 7, , + VMN You must wait until , P (or P ) and P (or a higher value) is displayed. This procedure (first reception of the necessary GPS data) may take a few minutes. The unit must remain switched on for the entire duration of this procedure. If after 5 minutes there has been no change in the values, the parked position (clear view in all directions as far as possible) or the installation location of the GPS antenna must be checked. Subject to correction and technical modifications 41 Copyright by Becker GmbH, D-76303 Karlsbad Installation guide · The menu for initial GPS start-up and for the sensor test is quit by simultaneously pressing the multifunction button and the multifunction button. Installation of the Navigation Software · · · · Press the button. Insert the Navigation CD to install the software for the navigation system. After the navigation software has been installed, the adjacent display appears. Select the language using the right rotary control selection is accepted by pressing the control. !#!B # ! You can choose either a male or a female voice for some languages. Select the voice using the right rotary control cepted and installed by pressing the control. The voice is ac- M The adjacent display appears after installation. The language selection can be changed at a later time, as described in the operating guide. " Subject to correction and technical modifications 42 Copyright by Becker GmbH, D-76303 Karlsbad Installation guide 12. During the journey, the speed signal (GAL) is automatically adapted to the vehicle-specific data and the gyro sensor is automatically adapted to the installation position of the unit. The distance to be covered depends on the type of vehicle and the local conditions. The navigation system is only ready for operation on completion of the calibration journey. · The adjacent display appears after the language installation. ! [. . . ] !& #"   Subject to correction and technical modifications 48 Copyright by Becker GmbH, D-76303 Karlsbad Installation guide Enter the correct tyre size using the right rotary control and confirm the entry by pressing for more than 2 seconds. Example: Specification in vehicle registration papers: 185/55R15 81T Input into unit: 185/055/015 Then select between $ !& !by turning the right rotary control to enter the approximate tread depth value. If correction is necessary, select & by turning the right rotary control and press to confirm. [. . . ]