User manual BEGLEC LED 4-BAR V1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. Standard flammable surfaces include building materials such as wood and wood-based materials more than 2mm thick. [. . . ] In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. If you don't like a messy installation with a lot of DMX cables hanging everywhere, just hide them inside the LED bar!To do this, just follow these steps: 2: Disconnect the earth conductor cable from the frame by removing its bolt and nut with a pincer. ALUMINIUM BODY: The aluminium enclosure is equipped with a sliding mechanism on both sides: BOTTOM SIDE: Use the 4 bolts/nuts (2) to attach the PAR projectors. [. . . ] END CAP: To install the bolts/nuts (needed to fix the projectors) and stand adapter you have to remove this end cap on one side of the unit: simply unscrew the 4 screws remove the cap put the nuts/bolts and/or stand adapter in the sliding rail put the cap back in place fix the 4 screws done! 3: Slide the front panel gently out of the frame so that you can take out the strain reliefs. 4: Gently tear out the strain reliefs and remove the small piece of "dummy" cable that we installed. 5: Place the strain reliefs around the readymade cables you bought from your supplier. [. . . ]