User manual BEGLEC MICRO SCAN LED VERSION 1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: LED MICRO SCAN unit Mains cable Operating instructions This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters. [. . . ] Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Standalone 1unit: Just connect the unit to the mains and put on some music. Two or more units in master/slave setup: Connect 2 or more units together using good quality balanced XLR microphone cables . The unit that has no cable connected to its input will react as master; the others are the slave units. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Din-5pin input, used to connect an optional wireless receiver, named RF-8R. This input receives instructions from a DMX-controller or from another Led Micro Scan light effect when used in master/slave mode. DMX output: 3pin female XLR-connector used to connect the Led Micro Scan with the next unit in the DMX chain or with another Led Micro Scan when used in master/slave mode. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. Mains Input: Fuse: Sound Control: DMX connections: DMX channels: Lamp: Size: Weight: AC 100 ~ 240V, 50/60Hz 250V 2A fast blow (20mm glass) Internal microphone 3pin XLR male / female 5 CREE 10W White LED 333 x 156 x 177mm (see drawing) 3, 0kg Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. [. . . ]