User manual BELSON CM2000

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] Indicator light "M" will come off and at this point, all the settings will have been cancelled. Interrupt the wash cycle by opening the appliance door with the You can cancel the wash cycle in progress, if it has only just started. If opening the door soon after the end of the program, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. The end of the wash cycle is indicated by a double beep and the flashing of the wash cycle indicator light "M". Open the dishwasher door, press the ON-OFF button as well, thus cutting off the electricity supply to the appliance. The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. A long beep will tell you that you have selected extra drying and the wash cycle will last longer in order to provide you with drier dishes. When you have loaded the dishes, you can choose when to start your dishwasher before setting the desired wash cycle. Press button "C" to delay the start of the wash cycle by 2, 4 or 6 hours. Each time you press it, you will hear a short beep and indicator light "D" corresponding to the selected delay will come on. Close the appliance door and, after you hear the beep, the countdown to the delayed start will begin. If the water in your home is hard you have the possibility to add salt in order to soften your water. The softer the water the better will be your washing and drying results. The salt container should be filled up when the low salt indicator light "S" flashes. Your appliance will remind you to do so for 5 consecutive wash cycles. 0 - 14 14 - 36 36 - 71 >71 0 - 17 18 - 44 0 -1, 7 1, 8 - 4, 4 Your dishwasher can adjust its salt consumption according to the hardness of the water in your home. This way, you can optimise and customise your dishwasher's salt consumption (not too much, nor too little). There is an arrow on the neck of the container (see figure): if necessary, turn the arrow anti-clockwise from the "-" setting to the "+" setting. Select the arrow position depending on the water hardness, referring to the table provided. 45 - 89 4, 5 - 8, 9 > 89 > 8, 9 If you don’t know your water hardness ask your local water supplier. NOTE: if you don’t find special water softening salt you can also use normal rock salt. If you have a problem, read this Your dishwasher may not work or not function properly. [. . . ] Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. If there are any stains on the surface of the appliance interior, use a cloth dampened with water and a little white vinegar, or a cleaning product specifically made for dishwashers. When you go away for an extended period of time, we recommend you do the following: • run a cycle with the dishwasher empty • turn off the water inlet tap. [. . . ]