User manual BELSON CM3328

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] If the appliance door is shut, press the Start button "R" and you will hear a beep; the cycle will start up within a few seconds. Your dishwasher is fitted with indicator lights (G) which light up to indicate the cycle phase under way. At all times, your dishwasher tells you which cycle phase is under way. You can modify the wash cycle in progress, if it has only just started. Keep the RESET button "R" pressed for about 5 seconds: a prolonged beep will sound, followed by three short beeps. Indicator light "G" will turn off and at this stage, all the settings will have been cancelled. When you have loaded the dishes, you can choose when to start your dishwasher before setting the wash cycle desired. Press button "D" to delay the start of the wash cycle by 12, 9, 6 or 3 hours. Each time you press it, you will hear a short beep and the indicator light "G" corresponding to the selected delay will light up. Press the start button "R" and after you hear the beep, the countdown to the delayed start will begin. Once this time is up, the indicator light will stop flashing and the wash cycle will begin. Put the dishwasher funnel on the hole and pour in approximately 70 oz. Never without salt Water hardness varies according to where you live. If the water in your home is hard you have the possibility to add salt in order to soften your water. The softer the water the better will be your washing and drying results. The salt container must be filled when the softener indicator light "S" comes on. Once you have loaded the salt for the first time, it is normal that the low salt indicator light stays on or flashes for 5 consecutive cycles. Your dishwasher can adjust its salt consumption according to the hardness of the water in your home. This way, you can optimise and customise your dishwasher's salt consumption (not too much, nor too little). There is an arrow on the neck of the container (see figure): if necessary, turn the arrow anti-clockwise from the "-" setting to the "+" setting. Select the arrow position depending on the water hardness, referring to the table provided. 45 - 89 4, 5 - 8, 9 > 89 > 8, 9 If you don’t know your water hardness ask your local water supplier. [. . . ] When the wash cycle has ended, always remenber to leave the appliance door ajar. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. If there are any stains on the surface of the appliance interior, use a cloth dampened with water and a little white vinegar, or a cleaning product specifically made for dishwashers. [. . . ]