User manual BOSCH 1591EVS

[. . . ] All of the warnings listed below refers to your mains-operated (corded) power tool or batteryoperated (cordless) power tool. Failure to follow all instructions listed below may Keep work area clean and well lit. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. If operating the power tool in damp locations is unavoidable a Ground Fault Circuit Interrupter (GFCI) must be used to supply the power to your tool. [. . . ] This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by the Canadian Standards Association. This symbol designates that this tool complies to NOM Mexican Standards. Disconnect the plug from the power source before making any Model number Voltage rating Amperage rating No load speed Stroke length Wood Aluminium Steel Stainless steel This system makes changing blades simple and fast. Insert the saw blade (teeth in cutting direction) until it latches in the plunger (Fig. ) When inserting the saw blade, the back of the blade must rest in the groove of the guide roller (Fig. When changing the blade, tool should be held so that the blade is safely ejected. PRECISION CONTROL The precision control guides were designed to improve vertical cut accuracy of the saw blade. To use this feature simply press the precision control button to close the guides for precision control. The saw blade is now guided laterally by the precision control guides which enables precision cuts. The precision control guides can be used for all applications, including bevel cuts. Precision control is recommended for cuts in thick wood, as the cutting angle is maintained and run-out of the saw blade is reduced. ATTENTION: The vacuum hose adapter must only be used with dust shroud when connected to a vacuum. When inserting the adapter tube into the footplate be sure that the plastic post of the adapter tube engages into the corresponding hole on the housing (Fig. Note: If the saw blade cannot be inserted into the plunger, the slots of the blade holder are not positioned as shown, or because the precision control guides are shut, push the blade ejector lever briefly to the front and release (Fig. To change the saw blade, push the ejector lever to the center stop; this releases the precision control guides and ejects the saw blade (Fig. To attach, hook overshoe over front of metal footplate and snap into place at rear of footplate (Fig. ANTI-SPLINTER INSERT To minimize splintering of the top surface of the material being cut, place the anti-splinter insert in the blade opening of the footplate (Fig. The anti-splinter insert can be inserted into the footplate in two positions. For narrow saw blades, place the insert completely to the front of the opening (Fig. For wider saw blades, place the insert completely to the rear of the opening (Fig. Note: This insert will only work with blades that have ground sides such as T301CD, T101B, T101D, and T101DP. [. . . ] cIRCLE AND PARALLEL CUTTING GUIDE (Not included , available as accessory) This accessory is available at an extra cost. Insert bar of guide through lock knob clamp, then through the slots provided in foot, from either side of foot with the edge guide facing DOWN (Fig. Hook lock knob clamp onto edge of footplate, adjust fence to desired width, and securely tighten lock knob clamp (Fig. Before attaching the guide, draw a circle and predrill a 13/64" center hole in workpiece. [. . . ]