User manual BOSCH DHL535BGB INSTALLATION INSTRUCTIONS

[. . . ]  The grease filter absorbs the grease contained in the vapours produced during cooking. Restrictions apply to the use of the extractor hood over a solid-fuel burner (coal, wood, etc. Gas hobs / Gas cookers Do not use all the gas hotplates simultaneously for a prolonged period (max. 15 minutes) at maximum thermal load, otherwise there is a risk of burns if the housing surfaces are touched or a risk of damage to the extractor hood. [. . . ] Activated carbon filter Removing and installing the activated carbon filter Extractor hoods with a filter mat: 1.  The wire grille is no longer required when an activated carbon filter is installed. Insert the screw through the wing nut and the sleeve and screw in the middle screw in the false bottom (required only during the initial installation). Screw, sleeve and wing nut are enclosed with the activated carbon filter. Insert the activated carbon filter at the rear, fold up and lock in the middle with the wing nut. Tape over the activated carbon filter with the enclosed sealing strip. Changing the activated carbon filter: If used normally (1 to 2 hours daily), the activated carbon filter should be changed approx. Activated carbon filters can be purchased from SPECIALIST OUTLETS (see optional accessories on the last page). Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants. 2005 10:08 Uhr Seite 21 Cleaning and care Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side.  At the same time as you renew the grease filter (see Filters and maintenance), clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Clean the extractor hood with a hot detergent solution or a mild window cleaning agent.  If the hood is extremely dirty (older stains), use a liquid window cleaner. Warning: Clean the control buttons with a mild detergent solution and a soft, damp cloth only. painted , aluminium and plastic surfaces: ❑ Do not use scouring agents or abrasive sponges.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. Even for some time after the bulbs have been switched off there is still a risk of burns. [. . . ] To ensure optimum extraction performance (especially important for kitchen island solutions): ❑ Install the extractor hood as high as possible within the structure ❑ The structure must cover the entire cooking area. The following cutouts must be made for the installation depending on the model: Extractor hood with rocker switch, 53 cm wide, 1-motor: m ṇ If the connection cable of this appliance is damaged, it must be replaced by the manufacturer, his customer service or a similarly qualified person in order to prevent a hazardous situation. Electrical specifications: The electrical specifications can be found on the rating plate inside the appliance when the filter frame has been removed. 2 1 min 3 60 - 0 in 15 50 0 -3 16 ṇ Do not place hand in the air outlet. [. . . ]