User manual BOSCH DWW 061461

[. . . ] Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. Circulating-air mode: ❑ An activated carbon filter must be fitted for this operating mode (see Filters and maintenance). The corresponding accessory numbers can be found at the end of these operating instructions.  The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen. [. . . ] Disposal of old activated carbon filters: ❑ Activated carbon filters do NOT contain any harmful substances. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. 17 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box.  At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood.  Do not scrape off any dirt that has dried on but loosen it up with a damp cloth.  Do not use abrasive cleaning agents or sponges that could cause scratches.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Clean the sliding switch with a soft, damp cloth (mild detergent solution) only. stainless steel surfaces: ❑ Use a mild non-abrasive stainless steel cleaner.  Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: ❑ Use a soft, non-linting window cloth or micro-fibre cloth. installation Instructions: Important information ṇ Old appliances are not worthless rubbish. Please ask your dealer or inquire at your local authority about current means of disposal. Additional information concerning gas cookers: ṇ You received your new appliance in a ṇ When installing gas hotplates, comply with the relevant national statutory regulations (e. Always comply with the currently valid regulations and installation instructions supplied by the gas appliance manufacturer. Only one side of the extractor hood may be installed next to a high-sided unit or high wall. Minimum distance on gas hotplates between the upper edge of the trivet and lower edge of the extractor hood: 650 mm, Fig. [. . . ] Then screw the flue duct to the sides of the fixing bracket with 2 short screws. Sätt in nytt kolfilter till höger och till vänster om fläktmotorn och vrid tills det sitter fast. Over et ildsted for faste brennstoffer hvor det er fare for brann (p. Bor 5 hull for dampheteen og 4 hull for holdevinkelen på pipeblenden med l 8 mm. [. . . ]