User manual BOSCH HBC86P753B

[. . . ] 39 Produktinfo Additional information on products, accessories, replacement parts and services can be found at www. Only then will you really be able to operate your appliance safely and correctly. Please keep the instructions for use and installation instructions in a safe place. Please pass on these manuals to the new owner if you sell the appliance. [. . . ] Close the door slowly and pull out the panel upwards by the ■ $ % Cleaning agents To ensure that the different surfaces are not damaged by using the wrong cleaning agent, observe the information in the table. Do not use ■ ■ sharp or abrasive cleaning agents, metal or glass scrapers to clean the glass in the appliance door, metal or glass scrapers to clean the door seal, hard scouring pads and sponges, cleaning agents with high concentrations of alcohol. Hold the intermediate panel firmly and press the safety catch on the door upwards. Area Appliance front Cleaning agents Hot soapy water: Clean with a dish cloth and dry with a soft cloth. Special stainless steel cleaning agents can be obtained from the after-sales service or from specialist shops. Hot soapy water or a vinegar solution: Clean with a dish cloth and dry with a soft cloth. Grip the upper section of the intermediate panel with both Oven hands and insert it into the guide at the bottom. The lettering must be positioned in the top right corner, so that it can be easily read. Glass cover for the oven light Control panel/outer door panel Inner door glass $ % Seal Accessories 18 3. Fully open the door, while holding the panels firmly with one & hand. Push the door downwards again and tighten the screws hand-tight using a flat-bladed screwdriver (blade width 811 mm), close the door. Push the door panel downwards, lift it slightly and hook it in at the top. ' ( Note: The oven may only be used again when the panels are correctly installed. Make sure that the door panel is sitting flush with the control panel. Please refer to the malfunction table before calling the after-sales service. If a meal does not turn out exactly as you wanted, refer to the Tested for you in our cooking studio section, where you will find plenty of cooking tips and tricks. Repairs may only be carried out by one of our trained after-sales engineers. Possible cause Faulty circuit breaker Plug not plugged in Power cut “Set clock” appears in the display. The Power cut during self-cleaning operation text “Set clock” appears in the display. Remedy/information Look in the fuse box and check that the circuit breaker is in working order. Turn the rotary selector to set the current time then press the 0 button. Turn the rotary selector to set the correct time then press the0 button. [. . . ] A core temperature of 60 °C should be maintained for at least 30 minutes. Due to the special cooking method, the meat always looks pink on the inside. Preheat the cooking compartment, thus warming the ovenware at the same time. Place the ovenware in the cooking compartment and restart ■ Slow cooking Note: Use ovenware with a properly fitting, matching lid, e. [. . . ]