User manual BOSCH PRB326B70E

[. . . ] Collect it in a sealed container and take it to an appropriate collection point or, failing that, place it in the rubbish bin (it will end up in a controlled dump; this is probably not the best option, but it will avoid contaminating ground water) IMPORTANT: In the unlikely event that the appliance should be damaged or not meet your expectations in terms of quality, please inform us as soon as possible. For the warranty to be valid, the appliance must not have been tampered with, or used inappropriately. Reading these instructions will enable you to use your appliance safely and effectively. Keep the operation and installation instructions and provide them along with the appliance if it is passed on to another user. [. . . ] It is essential to ensure that all the burner parts and pan supports are correctly installed for the appliance to work correctly. Press the chosen burner control knob and turn it anticlockwise to the required setting. Switching on automatically If your hob can be switched on automatically (ignition sparkers): 1. Press the chosen burner control knob and turn it anticlockwise to the maximum power setting. While the control knob is still pressed down, sparks are produced on all burners. The flame ignites (it is no longer necessary to press down the control knob). If it does not come on, turn the control knob to the off setting and repeat the steps above. This time, press and hold the control knob for longer (up to 10 seconds). If after 15 seconds the flame does not ignite, switch off the burner and open a nearby window or door. 8 Safety system Depending on the model, your hob may have a safety system (thermocouple) that prevents the flow of gas if the burners accidentally switch off. To ensure that this device is active, switch on the burner as usual and, without releasing the control knob, press and hold it down firmly for 4 seconds after lighting the flame. Thermocouple Ignition sparker Switching off a burner Power levels Setting Control knob off Maximum capacity or aperture and electricity on Minimum capacity or aperture Turn the corresponding control knob clockwise to the 0 setting. The progressive control knobs can be used to control the power needed, from minimum to maximum power. High flame Low flame For dual double-flame burners, the inner and outer flames can be controlled separately. The available power levels are as follows: Inner and outer flame on full power. Warnings It is normal to hear a slight whistling noise while the burner is operating. When it is first used, it is normal for the burner to give off odours; this does not pose any risk and does not indicate a malfunction; they will disappear in time. A few seconds after the burner is switched off, a sound (thud) will be produced. This is not a fault - this means that the safety device is no longer operating. Bear in mind that the ignition sparkers must not suffer any serious impacts. [. . . ] Technical Assistance Service When contacting our Technical Assistance Service, please provide the product number (E-No. This information is given on the specifications plate located on the lower section of the hob and on the label in the user manual. Warranty conditions The applicable warranty conditions are those set out by the company's representative office in the country of purchase. Proof of purchase must be presented to obtain the benefits of the warranty. [. . . ]