User manual BOSCH SENSIXX B1

[. . . ] When placed in a support, make sure that the surface on which the support stands is stable. The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again. Remove the plug form the socket before filling the appliance with water or before pouring out the remaining water after use. [. . . ] Unplug the appliance form the mains supply after each use, or if a fault is suspected. With the aim of avoiding dangerous situations, any work or repair that the appliance may need, e. Replacing a faulty mains cable, must only be carried out by qualified personnel from an Authorised Technical Service Centre. Unplug the iron from the mains supply when you have to leave the iron unattended. With the iron unplugged, fill in the tank of the iron with tap water and set the temperature dial to “max” Plug in the appliance to the mains. When the steam iron has reached the desired temperature (pilot light switches off), start steaming by setting the steam regulator to “2” and by repeatedly pressing the button . When using the steam function for the first time, do not apply it on the laundry, as there could still be dirt in the steam dispenser. Your new iron may smell and give off some smoke when you use it for the first time, this is normal and will cease after a short while. How to use the iron Check the laundry care label for the required ironing temperature. If you do not know what kind or kinds of fabric an article is made of, determine the right ironing temperature by ironing a part that will not be visible when you wear or use the article. Start ironing the articles that require the lowest ironing temperature, such as those made of synthetic fibres. € If the fabrics are damp enough, turn off the steam regulator completely. €Secure” auto shut-off function • •• ••• Synthetics Silk – Wool Cotton – Linen (Depending on model) The “Secure” auto shut-off function switches off the iron when it is left unattended, thus increasing security and saving energy. After plugging in the appliance, this function will be inactive for the first two minutes in order to give the appliance time to reach the set temperature. 8 Filling the water tank Set the steam regulator to the “0”position and unplug the iron from the mains!The addition of other liquids, such as perfume, will damage the appliance. Any damage caused by the use of the aforemen­ tioned products, will make the guarantee void. Do not use condensation water from tumble dryers, air conditionings or similar. To prolong the optimum steam function, mix tap water with distilled water 1:1. If the tap water in your district is very hard, mix tap water with distilled water 1:2. Before throwing a used appliance away, you should first make it noticeably inoperable and be certain to dispose of it in accordance with current national laws. Your Retailer, Town Hall or Local Council can give you detailed information about this. [. . . ] This appliance is labelled in accordance with European Directive 2002/96/EG – concerning used electrical an electronic appliances (waste electrical and electronic equipment – WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU. Check with another appliance or plug the iron into a different socket. Turn the temperature dial regulator to a higher position and wait until the pilot light switches off. [. . . ]