User manual BOSCH SPS59L12GB

[. . . ]   K  % K PLQ $ & K 6WDUW 5HVHW VHF       5HVHW  VHF               en Table of contents Washing the dishes . 16 16 16 16 16 17 17 17 17 18 18 18 18 18 19 19 19 19 20 20 21 21 21 21 22 22 23 24 24 24 24 25 25 25 25 26 26 26 26 27 27 27 Safety instructions . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. [. . . ] =/< Your dishes are being dried. 16 en Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display )*. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). nargoTiep m gthnoiterli tcuAomtiswa ihf/ Automatic switch off after end of programme or interior light* * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. Appliance switches off after 120 min. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Press X + or – button until the displayed time corresponds with your requirements. – To delete timer programming, press is the X + or – button until )* : indicated on the digital display. You can change your programme selection at any time until the programme starts. : : End of programme The programme has ended when the value : is indicated on the numerical display )*. – Close the door. – Hold down programme button # and press START button h until : . . . The LED for button # flashes and the digital display )* displays the factory setting : . Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . The set value is saved. 17 en Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Remove the utensils when they have cooled down. Intensive drying The final rinse uses a higher temperature which improves the drying result. – Hold down programme button # and press START button h until the digital display )* : . . . The LED for button # flashes and the digital display )* displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display )*. To change the setting, – Press the button 3 to switch the Intensive drying on : or off : . The set value is saved. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme – Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. [. . . ] The hot water setting : allows you to adjust your appliance optimally to operation with hot water. It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C. It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler. – Hold down programme button # and press START button h until : . . . [. . . ]