User manual BOSCH TAS 5542

[. . . ] €– This appliance is designed for pre­ a­ p ra­ion of small amounts of coffee for t domestic use or for use in non-com­ mercial, household-like environments, such as staff kitchens in shops, offices, agricultural and other small businesses or for use by guests at bed-and-break­ fast establishments, small hotels and similar residential facilities. €– Connect and operate the appliance only in accordance with the specifica­ tions on the rating label. €– Do not use your TASSIMO machine if either the power cord or appliance is damaged. €– Use indoors at room temperature only and not above 2000m sea level. [. . . ] To adjust the height setting for small cups, turn the control handle (7b) left to right until it clicks into place. To remove lift up the front of the cup stand and tilt towards the back. I¡ Notes: – To ensure the best possible beverage quality and avoid splashing, always use the highest cup stand position. € To avoid spillage, select the appropriate cup size for each type of beverage. The recommended cup size is indicated on the original T DISC outer packaging. Important: – For optimum results, fill the tank only with cool, fresh, non­carbonated water each day. To prepare your favourite beverage, proceed as follows: ► Turn the TASSIMO machine on by pressing the ON / OFF switch (1). – Place a suitable cup on the stand (7) according to the type of beverage. Adjust the height of the cup stand, if necessary, or remove it altogether for large cups or glasses. I¡ Note: Make sure that your TASSIMO machine has been set up for use as described in the section titled “First use of your TASSIMO machine” on page 4. Open the brewing unit by lifting the handle (4a) and then pushing the brewing unit up. Select a beverage T DISC and insert it into the T DISC holder (4b) with the printed side down. Make sure that the flap of the T DISC is located in the slot in the front. –► If you want a larger beverage, you can add more water immediately after the brewing process by pressing and holding the Start / Stop button (2) or the drink adjustment button + (2a). When the brewing process is complete, the Status LED F (3c) stops blinking. 2012 15:06:13 12 en Maintenance and day to day care Risk ¡¡ of electric shock!Clean your TASSIMO machine regularly to ensure that it continues to produce beverages of the best possible quality. If the appliance has been unused for a long time, run the cleaning process with the Service T DISC several times to ensure that the drinks it produces are of its normal high quality (see “First use of your TASSIMO machine”). Clean the brewing system regularly with a soft, damp cloth, especially the T DISC barcode scanner (4e) and the area around the clamp, so that the T DISC barcode can be scanned properly. Rinse out the water tank (5) and the filter cartridge holder (5c) by hand and with water only; do not place them in the dishwasher. It is recommended to clean these parts regularly, otherwise the drink outlet could become blocked, possibly causing leakage or reduced drink sizes. – When preparing a number of drinks one after another, the piercing unit may be manually cleaned quickly and easily under running water. [. . . ] Check that the appliance is prop­ erly plugged into the power supply. The water tank is not Make sure that the water tank is correctly positioned. En Solution Fill the water tank after the drink has finished dispensing and press the start / stop button to finish the drink. Window and try again or smooth the barcode on the T DISC out with your thumb. [. . . ]