User manual BOSCH WVD2452BGB INSTALLATION INSTRUCTIONS

[. . . ] – This appliance has been identified in accordance with the European Directive 2002/96/ EEC on Waste Electrical and Electronic Equipment (WEEE). This directive specifies a framework for the return and recycling of waste appliances, and is valid throughout Europe. Insert the covers (C), which you will find in the bag containing the documentation. Water supply Water inlet hose: Note: Do not bend, crush, modify or cut through the hose (the strength is no longer guaranteed). Optimum water pressure in the mains: 100-1000 kPa (1-10 bar) – When the tap is turned on, the water flow should be at least 8 l/min. [. . . ] Remove the hoses. Washing machine en Use a spirit level to align the washing machine. 1. Lock nut Appliance foot Ensure that: – the mains plug and socket are compatible, – the cable cross-section is adequate, – the earthing system has been installed correctly. 2. Use a spirit level to check the alignment of the washing machine and correct it if necessary. A damaged power cord must be replaced by an electrician only. If a residual current-operated circuit-breaker is used, use only a type which guarantees compliance with the regulations that are currently valid. Mains plug: – Do not insert into/pull out of the socket with damp hands. – Never pull the plug out while the appliance is operating. 2. Installing transport bolts For WM, WAX, WAE series Remove the four covers (C). Insert and tighten the transport bolts. D Installation instructions C 3. Hold the foot in place and make sure that the correct height is maintained. The lock nuts on all four appliance feet must be screwed tightly against the housing. For WS, WLX, WLG series Remove the four covers. Pull the bolt out of the sleeve until the end of the bolt is flush with the end of the sleeve. The lug on the washer must be located in the groove in the rear cover. Contents Safety instructions . To prevent unused detergent from flowing into the outlet during the next wash: Pour 1 litre of water into dispenser II and start the Empty (Drain) or Spin programme. Page . . . 1 . . . 1 . . . 1 . . . 1 . . . 2 . . . 2 . . . 2 . . . 3 . . . 4 . . . 5 . . . 6 . . . 7 Read the installation instructions before switching on the washing machine. Retain all documents for subsequent use or for the next owner. Manufacturer (see Instruction Manual) 0212/9000659503 5 6 7 Safety instructions – The washing machine is heavy – take care when lifting it. Do not install the washing machine outdoors and/ or in areas where there is a risk of frost. – In addition to the instructions mentioned here, special regulations regarding the relevant water and power supply companies may apply. – Lay hoses and cables in such a way that there is no risk of tripping. Removing the packaging Please remove the bottom foam and also foam support from the bottom of appliance when you are removing the packaging! Standard accessories Environmentally-friendly disposal – Dispose of packaging in an environmentally friendly manner. – This appliance has been identified in accordance with the European Directive 2002/96/ EEC on Waste Electrical and Electronic Equipment (WEEE). This directive specifies a framework for the return and recycling of waste appliances, and is valid throughout Europe. Covers for holes left by removing the transport bolts. Depending on the connection – A 24-40 mm dia. [. . . ] Mains plug: – Do not insert into/pull out of the socket with damp hands. – Never pull the plug out while the appliance is operating. 3. Hold the foot in place and make sure that the correct height is maintained. The lock nuts on all four appliance feet must be screwed tightly against the housing. Manufacturer (see Instruction Manual) 0212/9000659503 5 6 Transportation, e. g. [. . . ]