User manual BUFFALO WLI-U2-G300N : WIRELESS-N NFINITI USB 2.0 ADAPTER

[. . . ] User Manual AirStation Nfiniti Draft-N Wireless USB Adapter WLI-U2-G300N v. 1. 00 Getting Started · Insert the AirNavigator CD into the CD-ROM drive of your computer. · To launch the AirNavigator Setup Wizard manually, click Start, then Run. Type "D:\ Setup. exe", where D is the drive letter assigned to your CDrom. [. . . ] Select Disabled in the Startup Type field of Wireless Zero Configuration Service to enable the Wireless Zero Configuration Service. The default value of Wireless Zero Configuration Service is Automatic. I have more than one Air Navigator CD. The same Air Navigator CD works with all Buffalo Technology access points and wireless adapters. Please use the newest CD you have, with the highest revision number on it. 26 Glossary 10BaseT or 100BaseTX: 802. 3 based Ethernet network that uses UTP (Unshielded twisted pair) cable and a star topology. 802. 1x: The standard for wireless LAN authentication used between an AP and a client. Ad-Hoc Network: The wireless network based on a peer-to-peer communications session. Bandwidth: The transmission capacity of a computer or a communication channel, stated in Megabits per second (Mbps). BSS (Basic Service Set): An 802. 11 networking framework that includes an Access Point. Bus Mastering: A system in which the specified Input/Output device (e. g. NIC Card) can perform tasks without the intervention of the CPU. 27 Client: A PC or workstation on a network. Cross-Over Wiring: A UTP cable that has its transmit and receive pair crossed to allow communications between two devices. DCE (Data Communications Equipment): Hardware used for communication with a Data Terminal Equipment (DTE) device. Default Gateway: The IP Address of either the nearest router or server for the LAN. Destination Address: The address portion of a packet that identifies the intended recipient station. DHCP (Dynamic Host Configuration Protocol): Based on BOOTP, it uses a pool of IP addresses, which it assigns to each device connected to it, and retrieves the address when the device becomes dormant for a period of time. Glossary DNS (Domain Name System): System used to map readable machine names into IP addresses Driver: Software that interfaces a computer with a specific hardware device. DSSS (Direct Sequence Spread Spectrum): Method of spreading a wireless signal into wide frequency bandwidth. DTE (Data Terminal Equipment): Device that con10BaseT or 100BaseTx: 802. 3 based Ethernet network that uses UTP (Unshielded twisted pair) cable and a star topology. DCE (Data Communications Equipment): Hardware used for communication with a Data Terminal Equipment (DTE) device. Default Gateway: The IP Address of either the nearest router or server for the LAN. Default Parameter: Parameter set by the manufacturer. 28 Destination Address: The address portion of a packet that identifies the intended recipient station. DHCP (Dynamic Host Configuration Protocol): Based on BOOTP, it uses a pool of IP addresses, which it assigns to each device connected to it, and retrieves the address when the device becomes dormant for a period of time. DNS (Domain Name System): System used to map readable machine names into IP addresses Driver: Software that interfaces a computer with a specific hardware device. [. . . ] The following test methods have been applied in order to prove presumption of compliance with the R&TTE Directive 1999/5/EC: · EN 60950: 2000 Safety of Information Technology Equipment · EN 300 328-2 V1. 2. 1 (2001-12) Technical requirements for spread-spectrum radio equipment EMC requirements for spread-spectrum radio equipment · EN 301 489-17 V1. 1. 1 (2000-09) Taiwan: SAR compliance has been established in typical laptop computer(s) with CardBus slot, and product could be used in typical laptop computer with CardBus slot. Other application like handheld PC or similar device has not been verified, may not comply with related RF exposure rules, and such use shall be prohibited. Safety This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this manual and of the computer manufacturer must therefore be allowed at all times to ensure the safe use of the equipment. 37 FCC / CE / R&TTE Intended use: This device is a 2. 4 GHz wireless LAN transceiver, intended for indoor home and office use in USA, Canada, all EU and EFTA member states. [. . . ]