User manual CORBERO FC1780S-9

[. . . ] Before installing and using the appliance read this user's instruction book carefully. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. Symbol for ideas At this symbol ideas can be found according to food and its storing. [. . . ] rearranging the shelves is also possible when the door is open at an angle of 90°. After opening and closing the door of freezer vacuum will rise inside the appliance because of the low temperature. So wait 2-3 minutes after closing the door - if you want to open it again while inner pressure equalises. Take care of operating the freezer at a position of thermostatic control so that the inside temperature can never go above -18 °C, since temperature higher than this can deteriorate frozen foods. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. It is practical to replace frozen products into the wire basket(s) after freezing has finished. Doing this you could make room in the freezing compartment for another freezing. Do not forget to keep to the storage time given on the packaging of frozen products if you buy them frozen. to store home-frozen products see the storing instructions placed in the door of the freezer. Symbols signify the various foods, numbers mean maximum storing time given in months. In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. Bleeding part of the moisture of cooling chambers in form of frost and ice goes with the operation of the appliance. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases in the cooling chambers, they need more energy, at a certain thickness it does not allow the door of the freezing compartment to open. At this type of appliance defrosting the cooling plate of the refrigerator is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - the temperature of the cooling plate goes above 0 °C due to interior heating load of the compartment, so defrosting occurs. when the surface temperature of the cooling plate has reached +3 - +4 °C the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet leaded through the back into the evaporative tray maintained on the top of compressor and evaporates due to its warmth. Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. Do not leave the door open longer than necessary and avoid unnecessary openings. [. . . ] When placing the refrigerator keep minimal distances recommended in figure. Should the setting-up place or handling demand it, door-opening direction can be refitted from righthanded to left-handed. In figure the ZLKF 301 appliance can be seen, but the refitting is completely the same at the other (ZLKF 261) appliance. Following operations are to be done on the basis of figures and explanations: Break the circuit of the appliance. [. . . ]