User manual CORBERO FC260I

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. [. . . ] 2 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. cm 2 200 D027 D Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D388 C Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D023 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 A B D265 D339 14 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 D416 If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in fixing brackets (F), move the brackets as shown in the figure and re-tighten the screws. 11 8mm F G D415 D531 15 USE Starting-up and temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, located on the upper right side of the inner liner clockwise, beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. However, the thermostat knob setting should be adjusted depending on the temperature required inside the appliance. This, in turn, depends on a number of factors such as the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Turn the knob clockwise, to higher numbers, to obtain a lower temperature, or anticlockwise if a higher temperature is required. Food to be frozen should not be in contact with frozen foods in order to avoid an increase in temperature. Warning Never put fizzy drinks in the freezer as they might well burst. [. . . ] Reconnect the appliance to the power supply, start it up and, after half an hour, replace the foods previously removed from the freezer. Important Remember that an increase in the surface temperature of already-frozen foods may significantly decrease their storage life. Never use knives or metal objects to scrape away the accumulated frost as this might damage the cooling circuit. D037 18 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. [. . . ]