User manual CORBERO FD3290I

[. . . ] The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. [. . . ] cm2 200 D033 D Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D502 C Press in the joint covers between the appliance and the kitchen furniture. Fig. 6 D015 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 D503 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 A B D265 D353 14 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 D416 The upper compartment can be opened by means of the sliding system illustrated in the previous point, or else by attaching on the door the handle which is supplied as an accessory (see figure). Fig. 10a 8mm D415 D029 15 USE Starting-up and temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the top right hand side of the inner liner, clockwise beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. However, the thermostat knob setting should be adjusted depending on the temperature required inside the appliance. This, in turn, depends on a number of factors such as the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Turn the knob clockwise, to higher numbers, to obtain a lower temperature, or anticlockwise if a higher temperature is required. On the inner door of the compartment you will find a list of foods followed by a number. These numbers indicate the maximum period of time for which the food in question may be stored (in months). Important Do not put carbonated liquids (fizzy drinks, etc. ) in the freezer compartment as they may burst. Remember that, once thawed, frozen food deteriorates rapidly. Storage of frozen food Hints for the storage of commercially frozen food: Do not open the door frequently or leave it open longer than is absolutely necessary. [. . . ] During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. 18 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Clean the interior periodically with lukewarm water and some sodium bicarbonate; the cabinet exterior with a silicone wax spray; the condenser and the motor compressor with a brush or a vacuum cleaner. During periods when the appliance is not in use, take the following precautions: unplug the appliance from the power supply; remove all foodstuffs from the appliance; clean the interior and all accessories; leave the doors ajar to allow air to circulate inside the cabinet so as to prevent the formation of unpleasant odours. Replacing the interior light bulb The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. [. . . ]