User manual CORBERO FD5140I

[. . . ] " It is dangerous to alter the specifications or modify this appliance in any way. " Care must be taken to ensure that the appliance does not stand on the electrical supply cable. " The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. " Manufacturers' storage recommendations should be strictly adhered to. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. turn the hinge upside down and fit it on the other side of the cabinet, after having removed the covers which mask the holes provided for fixing; use the covers to mask the holes left open; refit the two doors and tighten the top and bottom hinges. 13 Important The centre hinge can be moved horizontally by about 3 mm to allow alignment of the doors, as follows: slacken the two screws securing the centre hinge to the cabinet and move the hinge until the doors are in line. Warning Once the opening direction of the doors has been changed, check that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (for example in winter), the seal may not adhere perfectly to the cabinet. In this case, wait for the seal to adapt naturally to its new position, or accelerate this process by heating up the area involved with a normal hairdryer. Warning A top seal is supplied loose with the appliance; this seal must be fitted before inserting the appliance into the recess (the holes for fixing it are pre-drilled). A plastic sealing strip is also supplied; snap it into place between the appliance and the kitchen unit. Fig. 3 Building and securing the appliance into the tall kitchen unit Recess height 1446 mm Recess depth 550 mm Recess width 560 mm D030 Fitting the appliance into the recess (Fig. 4) To position and secure the appliance inside the recess, proceed as follows: Fig. 1 A The dimensions of the recess for fitting the appliance into a tall kitchen unit must be as indicated in the table above. 200 cm Ventilation is provided though the bottom grille, se25 D140 cured to the bottom of the appliance, and through an opening to be cut in the base of the kitchen unit (minimum size 200 cm2 Fig. 1). 2 50 8 A D117 position the appliance inside the tall kitchen unit, pushing it against the inner side of the unit on which the door opens (Fig. 4); make sure that, with the door closed, the appliance is set back 8 mm from the front of the recess (Fig. Using the 6 screws provided, secure the bottom ventilation grille and the top seal (the holes are pre-drilled). Fig. 2 540 50 L P H A vent outlet, 50 mm deep by 540 mm wide must be cut in the top of the unit (Figs. 4-5) The accessories pack supplied with the appliance contains a device to allow the kitchen unit and appliance doors to be opened simultaneously. Fig. 5 C A B The device consists of guide (A), blocks (B), securi n g s c re w s a n d block covers (C). 4. C D118 To fit blocks (B), proceed as follows: open the appliance and kitchen unit doors to about 90°; position block (B) on the inside of the unit door as shown in Fig. 5; then secure it to the unit door, positioning the screws at the far left-hand end of the elongated holes in the block (Fig. 5); pressing lightly, slide the block towards the left (the elongated holes are provided for this purpose) until the device engages on the guide, so allowing simultaneous opening of both doors. [. . . ] Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place; leave the door open, and remove the water which forms during defrosting by means of a sponge of cloth; when defrosting is completed, dry the interior thoroughly; keep the scraper for future use; turn the thermostat knob back to the required setting or replace the plug in the power socket. D037 After two or three hours, reload the previously removed food into the compartment. Important: A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 18 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not come on when the door is open, check that it is screwed into place properly. [. . . ]