User manual CORBERO LD 2850

[. . . ] Tips and information about economical and ecological use of the machine are marked with this symbol. Our contribution to the protection of the environment: we use recycled paper. 23 ENGLISH Contents Warnings Disposal 25-26 26 Maintenance Bodywork Detergent dispenser drawer Drain filter Water inlet filter Emergency emptying out Frost precautions 40 40 40 40 40 41 41 Tips for environmental protection 26 Technical specifications Installation Unpacking Positioning Water inlet Water drainage Electrical connection 27 28 28 28 28 29 29 Something not working? 42-43 Changing the opening direction of the door and fitting a door panel 30 Your new washing machine Description of the appliance Detergent dispenser drawer 31 31 31 Use Control panel Controls Washing hints Sorting the laundry Temperatures Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives International wash code symbols Operating sequence Washing programmes 32 32 32 33 33 33 33 33 33 33 34 35 36-37 38-39 24 Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. · Any electrical work required to install this appliance must be carried out by a qualified electrician. [. . . ] To carry out this operation, proceed as follows: 1) Disengage the end of the opening stop (1) from the door and turn it through 90° to remove it from its seat (Fig. 2) Using a screwdriver, turn plastic plug (2) through 90° to remove it from its seat (Fig. 3 ) Fit plug (2) in the hole left free by opening stop (1 ) and turn it through 90° to lock it into place (Fig. 4) Fit opening stop (1) into the hole from which plug (2) was removed and turn it through 90°, making sure that the latching tooth is facing towards the right (Fig. 5) Remove the door by unscrewing the screws securing it to the bottom hinge (3 - Fig. A) by inserting a screwdriver into the upper hole and pushing downwards. 8) Remove plate (6) by inserting a screwdriver into the bottom hole and pushing upwards (Fig. 10) Remove the door catch (7) and plate (8) as explained in paragraph 7. 12) Refit the door catch (7) and plate (8), reversing their position and pressing firmly to engage the hook (Fig. Insert the top pin first, then the bottom pin into the hinge (3 - Fig. 15) Fit the flexible end of the door opening stop into the location provided in the door (1 - Fig. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. Use less detergent if: ­ you are washing a small load, ­ the laundry is lightly soiled, ­ large amounts of foam form during washing. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc. ), the colour, washing temperature and degree of soiling. All commonly available washing machine detergents may be used in this appliance: ­ powder detergents for all types of fabric, ­ powder detergents for delicate fabrics (60°C max) and woollens, ­ liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using concentrated powder or liquid detergents, a programme without prewash must be selected. The washing machine incorporates a recirculation system which allows an optimal use of the concentrated detergent. Pour liquid detergent into the dispenser drawer compartment marked just before starting the programme. Any fabric softener or starching additives must be poured into the compartment marked before starting the wash programme. [. . . ] Clean the filter under a running tap, then refit it, screwing it fully in. C0035 C0038 P0084 P0040 Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Water inlet filter If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. Refit the filter and screw the hose back onto the tap. P0038 P0041 40 5. Emergency emptying out If the water is not discharged (outlet pump is blocked, filter or drain hose are clogged), proceed as follows to empty out the machine: · pull out the plug from the power socket; · close the water tap; · if necessary, wait until the water has cooled down; · place a bowl on the floor; · put the drain hose end into the bowl and let the water come out. [. . . ]