User manual CORBERO LF880

[. . . ] MANUAL DE INSTRUCCIONES - INSTRUCTION BOOKLET Lavadoras Washing machines LF 680 LF 880 LF 1080 E GB 132998470 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. [. . . ] The water can be emptied out by pressing the button again (emptying will be followed by a spin) or by selecting the drain programme "N". If the button is not pressed, the programmes end with a spin. It will help you to choose the most suitable washing programme for your laundry. 2 Mains-on light It comes on when the machine starts operating and goes out at the end of the programme. 3 On/Off button Press this button to start the machine. Before selecting a programme or changing an ongoing programme the machine must be switched off by depressing the On/Off button. 7 Temperature selector dial (thermostat) To select the washing temperature turn the dial to the required value. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. 31 Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size. ENGLISH Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. (*) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Water hardness is classified in so-called "degrees" of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Follow the product manufacturers' instructions on quantities to use. [. . . ] Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: · Close the water tap and unscrew the water inlet hose from the tap. · Place the end of the drain hose and that of the inlet hose in a bowl placed on the floor. · Select programme "N" (drain) and run it until the machine stops. · Screw the water inlet hose back on and put the drain hose back in its place. [. . . ]