User manual CORBERO MO19M

[. . . ] Ice and ice-cream can cause hurt if they are eaten immediately after removal from the frozen food compartment. After dissolving frozen food must not be refrozen, it must be used up as soon as possible. Store pre-packed frozen food in accordance with the frozen food manufacturer's instructions. You must not make defrosting faster with any electric heating appliance or chemicals. [. . . ] Thermostat knob This is for setting and changing the temperature inside the appliance. Handling the appliance Putting it into use Put the plug into the mains socket. This time the red lamp starts giving light, the compressor starts and cooling begins shortly. When the red light goes out the temperature is sufficient and the appliance is suitable for storing frozen and deep-frozen foods. Controlling the temperature The thermostatic controller interrupts the operation of the appliance automatically for more or less time depending on the setting then restarts it assuring the required temperature. 20 GB Setting the thermostat knob can be done practically with a coin. Turning the control knob clockwise cooling becomes more and more intensive. In the appliance -18 °C or lower temperature can be reached if the thermostat knob is set according to the figure. The thermostat can be switched off (0 position), which means breaking the circuit of the compressor i. e. The temperature coming about in the freezer is effected by not only the position of the thermostatic control and the ambient temperature, but frequency of door openings and the quantity of food put into it, etc. In maximum position of the thermostat - in case of increased demand e. g. This does not cause damages to the appliance. Freezing Freezing different products should always be done in the freezing compartment after proper preparing. Move the fast freezer switch to the right (yellow lamp gives light) 4 hours before freezing food in small quantity and about 24 hours before in case of products in bigger quantity. This time the compressor operates continually to reach the temperature necessary for freezing. That is why you must not touch the electrical parts of the appliance before removing it from the mains socket. Problem The appliance does not cool sufficiently The appliance cools too hard The appliance does not cool at all Possible cause Thermostatic control is set too low. The thermostatic control is set too high. Solution Set higher position. Set lower position. The appliance is noisy Plug is not connected to the mains socket Check if the connection is proper. Check if the appliance stands stable (all the four The appliance is not supported properly. feet should be on the floor). Inasmuch as the advice does not lead to result, call the nearest brand-mark service. 24 GB Ins tr uctions f or the Ins t aller Technical data Model/Type Gross capacity (l) Net capacity (l) Width (mm) Height (mm) Depth (mm) Energy consumption (kWh/day) (kWh/year) Energy class, according to EU Standards Freezing capacity (kg/24h) Rising time (h) Rated power (W) Weight (kg) CV 850 S/2 (TT 120 F) 117 100 550 850 600 0. 90 329 C 16 17 120 39 Installing the appliance Transportation, unpacking It is recommended to deliver the appliance in original packaging, in vertical position considering the protective warning on packaging. After each transportation the appliance must not be switched on for approx. In that case retain packaging. Placement The ambient temperature has an effect on the energy consumption and proper operation of the appliance. When placing, take into consideration that it is practical to operate the appliance between ambient temperature limits according to the climate class that is given in the chart below and can be found in the data label. + 38 °C Cleaning Remove every adhesive tape, which ensure the parts not to move in the appliance. Wash the inside of the appliance using lukewarm water and mild detergent. After cleaning wipe out the inside of the appliance. If the ambient temperature goes below the lower data the temperature of the cooling compartment can go beyond the prescribed temperature. [. . . ] In case you do not want to perform the procedures above, call the nearest brand-mark service. Technicians will accomplish the refitting expertly for charge. 27 GB Electrical connection This refrigerator is designed to operate on a 230 V AC (~) 50 Hz supply. The plug must be put into a socket with protective contact. If there is no such, it is recommended to get an electrician to fit an earthed socket in compliance with standards near the refrigerator. This appliance complies with the following E. E. C. Directives: 73/23 EEC of 19. 02. 73 (Low Voltage Directive) and subsequent modifications, 89/336 EEC Compatibility modifications. [. . . ]