User manual CORBERO SC440

[. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. When used as an extractor unit, the hood must be fitted with a 150mm diameter hose. Should there already be a pipe of diameter 125 or 120 mm that ducts to the outside through the walls, it is possible to use the 150/125-120 mm reduction flange provided. [. . . ] If the hood is used in its recirculation mode, it will operate simply and safely in the above conditions without the need for any of the aforementioned measures. When the hood is used in its extraction mode, the following rules must be followed to obtain optimal operation: short and straight outlet hose keep bends in outlet hose to a minimum never install the hoses with an acute angle, they must always follow a gentle curve. Keep the hose as large as possible (preferably the same diameter as the outlet hole). The length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90° will reduce the efficiency of the hood and reduce the airflow. Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter. You will need an original charcoal filter for this function (Available from your local Service Force Centre). In this mode fumes are extracted to the outside via a hose connected to the coupling ring A. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Should there already be a pipe of diameter 125 or 120 mm that ducts to the outside through the walls, it is possible to use the 150/125-120 mm reduction flange provided. The charcoal filter can be ordered from your local Service Force Centre. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. If your appliance fails to work properly please carry out the following checks. Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently which will damage the hood. If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. ) This information is shown on the registration plate inside the unit behind the grease filter. [. . . ] If you require Customer Service in the Republic of Ireland please contact us at the address below: AEG Electrolux Group (Ire) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel: + 353 (0) 1 4090751 Email: service. For general enquiries concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. 1 plastic bag with screws, dowels and documentation 1 chimney support 1 deflector 1 reduction flange Ø 150-125 mm Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. [. . . ]