User manual DAIWA DLA-25H

[. . . ] This is equal to power increase by 26û times of the station of 3 which you talk with. [. . . ] In full duplex operating ÿ there may be noise in receiving band ÿ but it disappear when RX switch is off position. When off position ÿ transmit power of transceiver is thru (direct supply to antenna). In SSB mode ÿ transmi t5 receiving delay about I ': condo In FM operat Zö gÿ push the SSB knob to FM position. PRO When light on gives you warning about over voltage ÿ problems of antenna line and SW a4 · power meter . When connecting to handheld transceiver use a cabie with Rv4 (80239) connector and BNC connector at the end in accessory kit. Ru mobile transceiver use a cable with M connectors at both end · FUSE HOLDER Use only SA rating fuse when replace fuse. Because of heating of heatsink after continual use ÿ better suggested to place a funÿ and not use in a bad ventilated place or direct sun exposure. Input power should be less than 6W /DLA-25H ÿ 15W /DLA50HM ÿ or damage of WÕ}M sistor ÿ TVI may occur. [. . . ] W~it is necessary to extend th< units' power cable ÿ only use wire of the same gauge or thicker Connect the unit to a 12Aÿ 13ÿ 8V DC power supply ÿ or · [. . . ]