User manual FIRENZI FIDW41

[. . . ] DISHWASHER FIDW 41 INSTRUCTION BOOKLET UK Contents Safety instructions Disposal Economical and ecological dishwashing Description of the appliance The control panel Prior to using for the first time Setting the water softener Filling with salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine What to do, when. . . Service and Spare Parts Customer Care Department Guarantee Conditions Installation instructions Building-in Levelling Fixing to adjacent units Water supply connections Water outlet hose connection Electrical connection Hints for test centres 3 3 3 4 4 5 5 5 6 7 7 7 7 8 8 9 9 10 11 12 12 12 12 12 13 14 14 15 16 16 16 16 16 16 17 18 Technical specifications Dimensions Width Height Max depth Max depth with open door 59. 6 cm 81. 8 - 87. 8 cm 55. 5 cm 114 cm Electrical connection: Voltage Overall power Fuse Water supply pressure Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher's door. Minimum Maximum 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 2 Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. [. . . ] This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. (3) 10 Operating sequence In this fully integrated appliance the controls are located on the top of the door. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Set and start of the programme Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. Interrupting a washing programme in progress Interrupt a washing programme in progress ONLY if it's absolutely necessary. Open the door carefully. To interrupt a washing programme Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point in which it was interrupted. 5. Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. 11 Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. The dishwasher filter system comprises a coarse/fine filter (A/B), a microfilter (C) and a flat filter (D). Some dishwasher will only have a coarse filter (A), a microfilter (C) and a flat filter (D). Unlock the filter system using the handle on the microfilter, and remove. NEVER try to remove the upper spray arm. [. . . ] Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. We advise you therefore to remove it. Water supply connections This dishwasher must be plumbed into a cold water supply. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4" inch gas thread spout or to a purpose made quick-coupling tap such as the Press-block. [. . . ]