User manual FLUSHMATE 501-A

[. . . ] NEVER use any chemicals or corrosive household cleaners on FLUSHMATE Products. Note: It is normal for less than one inch of water to remain in the bottom of the china tank. INSTALLATION __________________________________________________________________ The Sloan FLUSHMATE ® Flushometer-Tank System Fixture installs in the same manner as other water closets. Using the gasket, washer and nuts provided with the fixture, assemble the tank to the bowl. [. . . ] NOTE: Adjust the Flush Valve Cartridge Assembly in quarter- to half-turn increments until the water stops running. If replacement of the Flush Valve Cartridge is necessary, follow the instructions in Step 5. TROUBLESHOOTING _____________________________________________________________ CONDITION: Weak or Sluggish Flush. If OK, then check the Flush System by removing the Tank Cover and tripping the Actuator. Water should flow freely and wash away any debris in the supply line and Vessel. To test the Air Inducer, place a small amount of water (2 to 3 drops) in the orifice of the Air Inducer cap and flush the toilet. If the Air Inducer is functioning properly the water will be drawn in. TO CLEAN AIR INDUCER: (Figures 3 & 4) a) Turn off the water supply and trip the Actuator. b) Unscrew the Air Inducer Cap, clean thoroughly and remove any obstructions. If the Air Inducer does not function properly, replace the Upper Supply Assembly. Turn the water supply off and drain the Vessel by tripping the Actuator and holding it down until completely drained. Next, pour a cup of water onto the Cartridge Housing area as shown in Figure 5. If a leak is detected (a steady flow of bubbles from the center of the Cartridge Area), the Cartridge should be replaced. Turn the water off and relieve the Vessel pressure by flushing the toilet. Reattach the supply line to the supply shank and observe connections to assure no leakage. IMPORTANT: If you are still experiencing a weak or sluggish flush after this point, it is recommended you replace the entire lower supply group. proper drain ventilation Consult a professional for their recommendations if any of these conditions exist. [. . . ] NOTE: Refer to fixture manufacturer's instructions for procedures to winterize bowl. POINTS TO REMEMBER ______________________________________________________ · When servicing any component, the water supply should be turned OFF and the Actuator tripped to relieve the pressure in the Vessel. · The Flush Valve Cartridge Assembly can be removed by inserting the handles of a pair of pliers into the top of the Cartridge and turning counter-clockwise. · It is normal for less than an inch of water to remain in the bottom of the outside China Tank. [. . . ]