User manual FUTABA CIU-2

[. . . ] USB INTERFACE Instruction Manual Thank you for purchasing a CIU-2. The CIU-2 is a USB interface for communications between Link supported devices and a Windows computer. [. . . ] Install the drivers and Link programs available on the dealer's website. Connecting and disconnecting the PC and CIU-2 Connection 1. Turn on the PC power. 3. When the CIU-2 is first connected to the PC; the "Found New Hardware Wizard" shown at the right is displayed. Install the drivers downloaded from the dealer' s website. USB port Disconnection The CIU-2 can be disconnected even while the PC power is on. However, do not disconnect the CIU-2 while it is communicating with a Link supported device. Example of connection to Link supported device (The figure below is an example of connection to an MC850C. ) Connection method 1. Connect the CIU-2 to the USB port of the PC. Connect the batteries to 2. Connect the Link supported device the Link supported device to the CIU-2. 3. Connect the batteries by referring to the Link supported device instruction manual. Power switch 5. Communication with the Link program is possible. Connect to PC USB port Connects the connector of the Link supported device. When connecting, use the accessory 500m extension cord, as required. Usage Precautions Do not disassemble the CIU-2. Do not open the CIU-2 case. Opening the case may damage the PC board. In this case, PC assembly replacement or repair will become impossible. [. . . ] Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, if not carried out properly. Symbol: :Prohibited :Mandatory <When requesting repair> Before requesting repair, read this instruction manual again. When there is an abnormality, request repair to your local Futaba dealer. FUTABA CORPORATION Makuhari Techno Garden Bldg. , B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan Phone: (043) 296-5119 Facsimile: (043) 296-5124 ©FUTABA CORPORATION 2007, 05 (1) [. . . ]