User manual HOTPOINT HHVP6.4FALK

[. . . ] The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite. CAUTION: Accessible parts of the hood may become hot when used with cooking appliances. Do not connect the appliance to the mains until the With regards to the technical and safety measures to be adopted for fume Discharging it is important to closely follow the regulations provided by the local The air must not be discharged into a flue that is used for exhausting fumes From appliance burning gas or other fuels. [. . . ] Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately. Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood. Information about the conversion of the hood from suction version to filtering version is present in this manual. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. If the hood is supplied with active charcoal filter, then it must be removed. Filter version The aspirated air will be degreased and deodorised before being fed back into the room. In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal. CONTROLS The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Note: The intensive extraction speed (power) is timed and lasts for 5 minutes (indicator c flashes); the hood then reverts to extraction speed (power) 2. ON/OFF Timer button: delays the deactivation of the selected extraction speed (power) by 5 minutes. Note: the button is also used for the "Filter saturation signal reset" function 4. Extraction speed (power): the indicator rotates according to the selected extraction speed (power). Grease filter saturation: comes on when filter maintenance is required. Active carbon filter saturation: comes on when filter maintenance is required. Note: this function is normally disabled and should only be activated if the hood is used as a filter version (with carbon filter fitted). To do so, proceed as follows: - switch off the hood - press and hold buttons 1 and 3 at the same time, until the indicator stops flashing (indicator disabled) and is lit steadily (indicator enabled). To deactivate it, repeat the procedure: the indicator will no longer be lit steadily (indicator enabled) and will flash instead (indicator disabled). Safety operation The hood has a sensor which, in the event of a sudden increase in temperature, activates the appliance until the temperature drops significantly. Filter saturation signal reset After carrying out filter maintenance, press and hold button 3 until indicator. MAINTENANCE Cleaning Clean using ONLY a cloth dampened with neutral liquid detergent. Perimeter aspiration panel Clean the perimeter aspiration panel with the same frequency as the ant-fats filter, using a cloth and not too concentrated liquid detergent. [. . . ] Then connect it in again and try once more before contacting the Technical Assistance Service. Please check the plate in order to verify the total absorption and the light absorption. Components not provided with the product Anmarkning: knappen anvands aven for funktionen "Aterstallning av signal for mattat filter" 4. Frityrsteking må overvåkes for å unngå at oljen blir for varm og antennes. [. . . ]