User manual HOTPOINT HIF9.7FABX

[. . . ] The air must not be discharged into a flue that is used for exhausting fumes from appliance burning gas or other fuels. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. The hood must NEVER be used as a support surface unless specifically indicated. Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. [. . . ] Use a duct with as few elbows as possible (maximum elbow angle: 90°). The company declines any responsibility whenever these regulations are Your cooker hood is ready to be used in suction version. To use the hood in filtering version the special ACCESSORY KIT must be installed. Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately. Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood. Information about the conversion of the hood from suction version to filtering version is present in this manual. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. If the hood is supplied with active charcoal filter, then it must be removed. Filter version The aspirated air will be degreased and deodorised before being fed back into the room. In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal. The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Note: The intensive suction speed (power) (LED L3 flashing) lasts for approximately 5 minutes, then the medium suction speed (power) is automatically set (LED L2 on) T3. LED high suction speed (power) L3 LED intensive suction speed (power) - timed (5 min. Flashing: carry out maintenance of the charcoal filter; on: carry out maintenance of grease filters. L5 LED low (silent) suction speed (power) Activation of the LED for charcoal filter saturation The LED for charcoal filter saturation is normally disabled. To activate it, proceed as follows: With the hood off, press and hold for a long time and simultaneously T1 and T4: L1 flashes first then L2 as well, to indicate successful activation. Disabling the LED for charcoal filter saturation: repeat the above operation, L1 and L2 start flashing first, then only L1, to indicate successful disabling. Automatic operation at high temperature The hood is fitted with a sensor that detects the temperature. When this becomes too high, the sensor automatically activates the medium suction speed (power). The hood switches off when the temperature detected by the sensor has lowered significantly. To select hood functions, simply touch the controls: Press once to select high suction speed (power) (LED L3 on); Press again to select intensive suction speed (power) (LED L3 flashing). [. . . ] The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy. This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. On the product, or on the documents accompanying the Product, indicates that this appliance may not be treated as household waste. [. . . ]