User manual HOTPOINT SDS 1722 J

[. . . ] Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operating controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Control. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Child proofing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In so doing, pay attention that the locating lug points backwards Fig. 6 4. 3. 8 Aligning the doors u If necessary, align the doors to the appliance housing by way of the two oblong holes in the bottom turn hinge Fig. 6 (25). 4. 3. 5 Transferring the handles On both the upper and lower door: u Transfer the spring clamp Fig. u Slide the spring clamp into place on the new hinge side until it clicks into place. WARNING Risk of injury due to the door dropping out!If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Check all of the screws and retighten if necessary. 4. 4 Insertion into a row of kitchen units Fig. 8 (1) Stack cabinet (2) Appliance (3) Kitchen cabinet (4) Wall Fig. 9 6 Control The appliance can be inserted into a row of kitchen units. 9 (2) to the height of the row of units, a suitable stack cabinet Fig. depth 580 mm), the appliance can be installed directly next to the kitchen unit Fig. u Store perishable food such as ready-to-serve dishes, meat products and sausages in the coldest zone. Place butter and preserves in the upper area and in the door (see Appliance at a glance). u Use recyclable plastic, metal, aluminium and glass containers and cling film for wrapping. u Always store liquids and food which is subject to odour or taste transfer in closed containers or cover them. u Foods which give off a large amount of ethylene gas and delicate foods, such as fruit, vegetables, salad, should always be stored separately or wrapped so as not to reduce the storage life; e. g. u Do not store food too close together to enable good air circulation. u To safeguard bottles from tipping over: move the bottle holder. w The fan symbol Fig. 10 5. 3. 4 Relocating the shelves The shelves have stops preventing them from being unintentionally pulled out. w The food does not freeze onto the rear wall. 5. 3. 5 Using the sectioned shelf 5. 3. 2 Setting the temperature The temperature depends on the following factors: - the frequency of opening the door - the room temperature of the installation location - the type, temperature and quantity of the food Recommended temperature setting: 5 °C This means an average temperature of approx. Once the 2 °C setting is reached, the sequence starts again at 9 °C. u To change the temperature in 1 °C increments, press the adjustment button, Fig. [. . . ] A LED on the bottom rear of the appliance (at the compressor) flashes regularly every 15 seconds*. Speed-controlled* compressors may produce varying running noise due to different speed steps. u The sound is normal. 6. 4 Customer service First check whether you can correct the fault yourself by reference to the list (see Malfunction). If this is not the case, please contact the customer service whose address is given in the enclosed customer service list. This noise comes from the refrigerant flowing in the refrigeru The sound is normal. A quiet clicking noise. [. . . ]