User manual INDESIT D 16B1 A NX

[. . . ] Operating instructions, 1 Precautions and advice, 3-4 Product Data, 10 Assistance, 13 Installation, 24-25 Description of the appliance, 26 Refined salt and rinse aid, 27 Loading the racks, 28-29 Detergent and dishwasher use, 30 Wash cycles, 31 Care and maintenance, 32 Troubleshooting, 33 This appliance was designed and manufactured in compliance with international safety standards. The following information has been provided for safety reasons and should be read carefully. If the appliance is sold, given away or moved, make sure the manual is kept with the machine. Read the instructions carefully, as they include important information on safe installation, use and maintenance. [. . . ] When the LOW RINSE AID indicator light in the control panel is lit *; · When the green float* on the cap of the salt dispenser is no When the LOW RINSE AID indicator light on the panel/display is lit *; · When the dark optical indicator* on the dispenser door "D" See autonomy in the water hardness table. Remove the lower rack and unscrew the Only the first time you do this: fill the water Fill the salt container right up to its edge (approximately 1 kg); it is not unusual for a little water to leak out. Remove the funnel and wipe any salt residue away from the opening; rinse the cap under running water and then screw it on. It is advisable to perform this procedure every time you add salt to the container. Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash cycle (this could damage Open the dispenser "D" by pressing and pulling up the tab on the lid; 2. They can be used in a vertical position when arranging dishes Crockery and empty liquids from glasses and containers. Arrange the crockery so that it is held in place firmly and does Not tip over; and arrange the containers with the openings facing Downwards and the concave/convex parts placed obliquely, Thus allowing the water to reach every surface and flow freely. Make sure that the lids, handles, trays and frying pans do not Prevent the sprayer arms from rotating. Since plastic dishes and non-stick frying pans usually retain more Water drops, their drying will be not so good as that of ceramic Lightweight items such as plastic containers should be placed in the upper rack and arranged so that they cannot move. After loading the appliance, make sure that the sprayer arms The modular basket is equipped with top grilles for improved The cutlery basket should be positioned Only at the front of the lower rack The lower rack can hold pans, lids, dishes, salad bowls, cutlery Large plates and lids should ideally be placed at the sides. Knives and other utensils with sharp edges must be placed in the cutlery basket with the points facing downwards or they must be positioned horizontally in the tip-up compartments on the upper rack upper rack Load this rack with delicate and lightweight crockery such as glasses, cups, saucers and shallow salad bowls. Very soiled dishes and pans should be placed in the lower rack because in this sector the water sprays are stronger and allow a higher washing performance. They can be used in a vertical position when arranging tea/ dessert saucers or in a lower position to load bowls and food containers. *Only available in selected models with different numbers and Tip-up compartments with adjustable position The side tip-up compartments can be positioned at three different The upper rack can be adjusted for height based on requirements: high position to place bulky crockery in the lower rack and low Heights to optimize the arrangement of crockery inside the rack. Position to make the most of the tip-up compartments/sectors Wine glasses can be placed safely in The stem of each glass into the corresponding slots. To change the inclination, pull up the tip-up compartment, slide it slightly and position it as you wish. Adjusting the height of the upper rack In order to make it easier to arrange the crockery, the upper rack may be moved to a higher or lower position. The height of the upper rack should be adjusted WHEN THE RACK IS EMPTY. If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the lower position, press the levers (A) at the sides of the rack and follow the rack down. Parts in synthetic material which do not withstand high The colours of glass decorations and aluminium/silver pieces can change and fade during the washing process. Only use glasses and porcelain guaranteed by the Use a delicate detergent suitable for crockery. [. . . ] Remove the cup filter B by exerting a slight pressure on the side flaps (fig. Clean the seals around the door and detergent dispensers REMOVE the wash-cycle pump protection (black detail) (fig. This will avoid food becoming Trapped in the seals, which is the main cause behind the Cleaning the spray arms Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. [. . . ]