User manual INDESIT IDCA G35

[. . . ] Where to install the tumble dryer Ventilation General safety Saving energy and respecting the environment Disconnecting the power supply Cleaning the filter after each cycle Checking the drum after each cycle Emptying the water container after each cycle Cleaning the condenser unit Cleaning the tumble dryer How to carry out a drying cycle, 10 This symbol reminds you to read this instruction manual. Always store this manual close to the tumble dryer and remember to pass it on to any new owners when selling or transferring the appliance, so they may familiarise with the warnings and suggestions herein contained. Read these instructions carefully: the following pages contain Important information on installation and useful suggestions for operating the appliance. Where to install the tumble dryer GB If the dryer is installed below a worktop, Any objects above it, The sides of the machine The appliance must be installed with the rear Make sure that the dryer is installed in a room free of humidity and with adequate air circulation. [. . . ] After closing the door, press the START/PAUSE button to resume machine operation. The fabrics are cooled) activates during the last few minutes of the drying programme; always allow this phase to terminate. The buzzer will beep 3 times to let you know that your programme is complete. Open the door, remove the laundry then clean the filter and replace it. Empty the water container and put it back in its slot (see Care and maintenance). If the "Post Care" option was selected and laundry is not removed immediately, the drum will rotate garments at intervals for 10 hours or until the door is opened. Standby mode This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Note: * The duration of these programs will depend on the size of the load, types of textiles, the spin speed used in your washer and any extra options selected. ** Standard Cotton is the more efficient program in terms of energy consumption (EU 392/2012). To reach maximum efficiency, select the highest temperature option (Standard/Default starting configuration) special/Sport/Partial Programmes Energy Saver Cycles The Energy Saver Cycles reduce energy consumption and so they not only help the environment, they also cut your energy bill!Energy Saver Cycles are available for several different types of fabric. They have been designed to give excellent drying performance for small loads. Energy Saver Cycles give the best drying results thanks to perfect temperature regulation and to accurate humidity detection which is optimized to obtain the best result on small load. Loads dried using this programme are usually ready to use, but on some garments may be slightly damp. If this is found try Removing the load and open them out or turn inside out then run the programme again for a short period. Wool Programme This programme is specific for items that withstand tumble drying and are labelled with the symbol. This programme lasts about 60 minutes, although it may last longer depending on the size and density of the load and on the spin speed used during the wash cycle. Garments dried with this programme are usually ready to be worn, although the edges of heavier garments may be slightly damp. Leave them to dry naturally, as an additional drying process may damage them. Unlike other materials, the shrinking process in wool is irreversible, i. The shoes must have been previously washed and spun at a minimum spin speed of 400 revolutions. A specific shoe rack is provided and must be used, otherwise the dryer will be damaged if shoes are dried in the drum. [. . . ] Press and hold the ON/OFF button until the dryer reactivates Before contacting the Technical Assistance Centre: GB ?Follow the troubleshooting guide to check whether problems can be solved personally (see Troubleshooting). If not, switch the dryer off and contact the Technical Assistance Centre closest to you. Provide the following data when contacting the Technical Assistance Centre: Attempting to repair it personally or with the aid of an unqualified personnel may put the safety of people at risk, damage the machine or invalidate the spare parts guarantee. [. . . ]