User manual INDESIT WIDL126S

[. . . ] Remove the four protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). Connect the supply pipe to the water mains using a gas 3/4 attachment, fitting the rubber gasket and the filter supplied with the appliance and ensuring that they are fimly tightened to the taps. The water supply marked C must be connected to the cold water tap; the pipe marked H must be connected to the hot water tap. Both pipes may be connected to the cold water tap using the special Y connection with multiple attachments, supplied with the appliance (see figure). [. . . ] START/RESET button: to start the programmes or cancel any incorrect settings. ON-OFF/DOOR LOCK Led: to find out whether the Washer-dryer is on and if the appliance door can be opened (see page 7). This is what they can tell you: Delay set: If the Delay Timer function has been enabled (see page. - when the drying cycle is complete, the indicator will flash, to indicate that light relative to phase the DRYING knob needs to be set back to the 0 setting. If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. Precautions Care Troubleshooting ON-OFF/DOOR LOCK led: If this LED is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any damages, wait for the LED to flash before you open the appliance door. Service  The rapid flashing of the ON-OFF/DOOR LOCK Led together with the flashing of at least one other LED indicates there is an abnormality. All the LEDS will light up for a few seconds and the ON-OFF/DOOR LOCK Led will begin to flash. Load your laundry into the washing machine and shut the appliance door. To cancel it, keep the START/RESET button pressed for at least 2 seconds. Wool: for best results, use a specific detergent, taking care not to exceed a load of 1 kg. • Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. • Before loading your laundry into the washing machine, make sure the drum is empty. • Do not use the appliance to dry clothes that have been washed with flammable solvents (e. • Do not use the appliance to dry foam rubber or similar elastomers. • Make sure that the water tap is turned on during the drying cycles. • This washer-dryer can only be used to dry clothes which have been pre-washed in water. Saving on detergent, water, energy and time • To avoid wasting resources, the Washer-dryer should be used with a full load. A full load instead of two half loads allows you to save up to 50% on energy. ╠The pre-wash cycle is only necessary on extremely soiled garments. Avoiding it will save on detergent, time, water and between 5 and 15% energy. [. . . ] Sometimes, small items (such as coins or buttons) may fall into the pre-chamber that protects the pump, situated in the lower part of the same. Using a screwdriver, remove the cover panel on the lower front of the Washer-dryer (see figure); Cleaning your appliance The exterior and rubber parts of your appliance can be cleaned with a soft cloth soaked in lukewarm soapy water. Cleaning the detergent dispenser Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. [. . . ]