User manual JANOME S7

[. . . ] When using an electrical appliance, basic safety precautions should always be followed, including the following: This sewing machine is designed and manufactured for household use only. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. wARNING-- To reduce the risk of burns , fire , electric shock , or injury to persons: 1. Close attention is necessary when this sewing machine is used by or near children. [. . . ] The corners should be cut /0 Place the facing on the wrong side of the garment Mark the 4 corners with pins as shown. /1 Turn all the layers over and cut the buttonhole opening on the facing in the same way as step x. y Facing u Garment fabric /2 Stitch around the opening with a needle and thread as shown. Corded Buttonhole To sew a corded buttonhole, follow the same procedure as for B1 square (sensor) buttonhole. Bring up the ends of the cord and insert both ends between the ribs and metal plate. Q Spur w Metal plate Set the stabilizer plate as necessary and attach the buttonhole foot. q X Lower the needle into the fabric where the buttonhole will start. C Cut the filler cord at both ends as close to the buttonhole as possible. Set the stitch width in accordance with the thickness of the cord used. Z Attach the automatic buttonhole foot R and pull the button holder all the way out. Place the fabric under the foot, and lower the needle at the starting point. q Button holder w Starting point X Start the machine and sew to the required length, then press the reverse button. e Reverse button r Required length C Sew another layer of darning over the first layer, at a right angle to it. To sew the same size darning When finished sewing, a confirmation message will appear. Simply start the machine to sew another layer of darning stitches in the same size. To sew the next layer of darning stitches in a different size, press the X key. Sew the first line to the desired length and stop the Press the reverse button and start the machine again. The machine will sew the rest of the darning and stop To adjust the evenness of darning stitches You can correct unevenness of darning stitches by pressing the "­" or "+" key of the adjusting window. If the left corner is lower than the right side, press the "­" key to correct it. If the right corner is lower than the left side, press the "+" key to correct it. To sew: Place the garment under the foot and lower the needle to the starting point. Q Starting point Open the eyelet with an awl, puncher or pointed scissors. [. . . ] Do not dismantle the machine in any way other than as explained in this section. cAUTION: Do not store the machine in a high-humidity area, near a heat radiator, or in direct sunlight. w Lint brush e Soft cloth C Clean the feed dog and auto thread cutter device with the lint brush. r Feed dog t Auto thread cutter device V Clean the hook race with a soft cloth. [. . . ]