User manual JONSERED 600 SD

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. Read this manual carefully and make sure you understand all controls and their function. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] In this case, do not tilt it more than absolutely necessary and lift only the part which is away from the operator. Do not start the engine when standing in front of the discharge chute. Stop the engine and disconnect the spark plug wire: before clearing blockages or unclogging chute; before checking, clearing or working on the mower. After striking a foreign object, inspect the mower for damage and make repairs before restarting and operating the mower. Check for fuel leaks and make sure all fasteners are in place and securely fastened. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. Store tool and fuel in an area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. Do not smoke or allow smoking near fuel or the tool or while using the tool. Loosen the wire/cable from the handle before carefully folding the handle. The mower should not be used on ground that slopes more than 30°. These symbols may appear on your machine or in the literature supplied with the product. Adjust to desired cutting level by means of the lever at either wheel. To start a cold engine, push primer three (3) times before trying to start. [. . . ] Never cut more than 1/3 of the length of the grass, especially during dry periods. The spark plug must be at the highest point on the mower when it is tilted up. Note: the dipstick must be screwed all the way down in order to indicate correct oil level. [. . . ]