User manual JUKI DX7

[. . . ] Please read this instruction manual before using the machine as it contains important operational and safety information. Keep this manual accessible so that you may refer to it at anytime while operating the machine. When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this sewing machine. Always unplug this appliance from the electric outlet immediately after using and before Do not allow this appliance to be used as a toy. [. . . ] Then pierce a stopper pin at the bartack and open the buttonhole with a ripper. It will be easier to sew buttonholes on the thin fabrics and/or near the overlapped sections, if the clamping plate is used. Attach the buttonhole presser foot to the presser foot holder, with the clamping plate together. Buttonholes with gimp thread prevent the buttonholes from stretching and can make them more secure. * A buttonhole with gimp thread should be sewn using the double bartack pattern (Pattern No. 1 Pass the needle thread through under the presser foot and then draw the thread to The side of the presser foot. Presser foot, pull the gimp thread under The presser foot and thread it at the hook 3 After threading at the hook, pull the gimp thread back under the presser foot and put it into the notch at the front left side of the presser foot firmly. 4 Bring down the needle to the sewing start point and lower the presser foot. 6 Pull the left gimp thread to take off slack and cut excess gimp thread. When changing the width of the buttonhole When the power is shut down or anoth- Turn to the left Turn to the right When changing the density of the seam Turn to the left Turn to the right Pushing "+" * The width of buttonhole can be changed by ( Turn OFF the power switch before replacing the presser foot. * Turn the "zigzag width" and "stitch length" adjusting dials before sewing when you want to change the buttonhole width and density of the seam. Hole on the presser foot 1 Set the manual buttonhole presser foot (I). 2 Pass the needle thread through the hole of the presser foot and pull it out sideways together. 3 Bring down the needle on the sewing start point and lower the presser foot. * At this time, if the start/stop button is pushed, the machine will stop sewing. And if the start/stop button is pushed again, then the machine will continue to sew the left side of the buttonhole. Push the reverse stitch button when it reaches the necessary length of the left side of the buttonhole. Sew bartack and the right side of the buttonhole, then the machine sews bartack and right side of the buttonhole. reverse stitch button 6 Sew bartack and lock stitches until the machine stops automatically. 7 Pierce a stopper pin at the bartack and open the buttonhole with a ripper. As the numbers of stitches of both right and left lines of buttonhole is memorized in the sewing machine, the buttonhole of the same size can be sewn. * If you want to change the memory, select the stitch pattern once again. [. . . ] Turn the spool holder until it engages the positioning stopper F with a click. draw the Thread from the spool which is thickly wound with thread you have placed on the spool holder. Put the thread on thread guide G-1 and G-2 in the written order and thread the machine head as usual. 2 Open legs of Wide Table until they stop securely at the stopping position. [. . . ]