User manual JUNO JDK8830A

[. . . ] 3. 2 - Before connecting to the mains supply ensure that the mains voltage corresponds with the voltage on the rating plate inside the hood. 3. 3 - Connect the cooker hood to the mains via a double pole switch which has 3 mm clearance between the contacts. 3. 5 - When istalled, the hood must be positioned at least 65 cm above a cooking appliance. [. . . ] 4 - Pilot drill all the hole positions as marked on the wall using an 8 mm drill and fix the wall brackets 1-2 using the rawl plugs and screws supplied. 5 - Splashback (optional) When a splashback is to be fitted, the distance between the cooker hood and the cooking appliances will be determined by the height of the splashback, item F. If the splashback is to be fixed to the wall using both the top and bottom fixing holes care must be taken to ensure that the splashback is fitted at the correct height before fixing it into position. The fitting should be undertaken by a a competent person with experience in this type of installation. If the splashback is to be fixed through only the top fixing holes proceeds as follows: a) Put the splashback on the worktop as illustrated in fig. 2; then holding it against the wall to ensure that it is correctly positioned. c) Pilot drill the wall using an 8 mm drill and fix the splashback using the 8 mm rawl plugs and screws supplied. d) If the fixing holes in the bottom of the splashback are not to be used to secure the splashback to the wall the installer should ensure that the bottom edge is tucked down behind the rear of the worktop. 4. 2 - Fixing the canopy hood (fig. Adjust the two screws R located on the hood hooking points, at about an intermediate position. Hook the hood unit to bracket 1 inserting the 2 tongues in the wide parts of the eyelet hooking holes and push down until stopped by the adjustment screws R. Adjust the hood vertically and level it horizontally with the two screws R. 4. 3 - Electrical connection and working test 1 - The safety measures 3. 2, 3. 3 and 3. 4 of paragrapf 3 are to be strictly observed. 2 - Once the electrical connection has been completed, check that worktop illumination, motor and speed work properly. 4. 4 - Ducting or Recirculation fitting 1 - Ducting fitting a) The cooker hood can be ducted to the outside using either rigid or flexible fire retardant ducting of 120 or 150 mm. When 120 mm ducting is to be used it will be necessary to install the reduction flange item A on the air outlet fig. b) The installer should provide suitable ducting and sealing material for the installation. [. . . ] b) Pull the glass diffuser slightly to one side until it disconnects from the lug on the other side (arrow 1), then pull slightly downwards (arrow 2) and slide in the opposite direction (arrow 3) until the glass diffuser can be removed. Replace the lamps or the neon strip and replace the glass diffuser by repeating the above operations in reverse order. c) If illumination is provided by spotlights beside the control panel, these can be replaced simply by removing the metal grease filters. [. . . ]