User manual JUNO JKG6473

[. . . ] " It is dangerous to alter the specifications or modify this appliance in any way. " Care must be taken to ensure that the appliance does not stand on the electrical supply cable. " The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. " Manufacturers' storage recommendations should be strictly adhered to. [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. D023 min. cm 2 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 200 D027 Fig. 2 A Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A Cleaning the interior D265 Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 12 Fig. 8 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided in the kit included with the apC D388 pliance. 5 8mm PR34 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 Press in the joint covers between the appliance and the kitchen furniture. D098 Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, PR35 if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (F), move them as shown in Fig. 9a Apply covers (B) on joint cover lugs and into hinge holes. B F D339 G Fig. 7 H 20m m D094 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. D398 13 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. Fresh food refrigeration To obtain the best performance: do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. [. . . ] 14 Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. Rinse and dry thoroughly. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. D206 CUSTOMER SERVICE What to do if the appliance is not functioning properly. If something is not working properly, check that: the plug is firmly in the wall socket and the mains power switch is on; there is an electricity supply (find out by plugging in another appliance); the thermostat knob is not on the «OFF» position. Furthermore: If the appliance seems too noisy, check that the sides are not touching furniture that can transmit or amplify a noise or a vibration. [. . . ]