User manual JUNO JKI 4434

[. . . ] Numbered instructions guide you step by step in the operation of the appliance. . . . 3 2 Supplementary information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Explanations of the technical terminology used in the operating instructions can be found at the end in the section "Technical Terminology". The operating instructions contain instructions for the correction of possible malfunctions by the user in the section "What to do, if . . . ". [. . . ] In order not to impair the function of the appliance, never cover or obstruct the ventilation openings. 2 min. 200 cm 20 Installation See , , Installation Instructions" supplied. Please check whether, after installing your appliance and especially after rehingeing the door, the door seal seals right round. An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. . . "). Electrical Connection Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. A correctly installed, earthed socket is required for the electrical supply. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). Attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. 21 Appliance Description View of Appliance (various models) Control panel Butter and cheese compartment with lid Variable door storage compartment Door storage compartment Bottle compartment Prior to Initial Start­Up 1. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). Tip: Food in the fridge should always be covered or packaged, to prevent drying and tainting of other food. The following are suited for packaging: ­ Polyethylene airtight bags and wraps; ­ Plastic containers with lids; ­ Special plastic covers with elastic; ­ aluminium foil. Defrosting The Fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. The water from the thawing frost is collected in the drain channel on the rear of the fridge, feed through the drain hole into the collector on the compressor, and then evaporated. The condensation water drain hole must be cleaned regularly (see the section "Cleaning and Maintenance". 26 Cleaning and Maintenance For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. 1 · · · · Warning!Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Moisture could accumulate in electrical components, danger of electrical shock!Do not use defrosting sprays, they can be hazardous to your health and/or contain substances that damage plastics. The appliance must be dry before it is placed back into service. 1. Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Clean the appliance and the interior accessories with a cloth and lukewarm water. Clear a blocked drain hole with the aid of the green strip inserted into the drain hole. Attention! · Ethereal oils and organic solvents can attack plastic parts, e. g. [. . . ] same time shape the warmed door seal by hand such that it sits correctly. The compressor does not start The compressor starts after a period immediately after changing the This is normal, no error has occurred. See the "Cleaning and Maintenance" section. 28 Changing the light bulb 1 Warning!Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. To switch off the appliance, turn the temperature regulator to position "0". 2. [. . . ]