User manual JUNO JKI4331

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. directive number 87/308 of 2. 6. 87 relative to radio interference suppression. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +16°C and +32°C. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the inside Before using, clean all inside parts with warm water and neutral soap to remove the typical new smell. Do not use abrasive detergent or powders as these can damage the finish. 12 Building-in instructions Dimensions of the recess Height of housing mm 880 Depth of housing mm 550 Width of housing mm 560 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. cm2 200 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. cm 2 200 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. 4 D028 Push appliance into the housing until stop strip (A) touches the kitchen unit. Fig. 2 A D C D130 Press in the joint covers between the appliance and the kitchen furniture. Fig. 5 D022 D128 13 Apply covers (B) on joint cover lugs and into hinge holes. Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 9 B D013 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. Remove catch (3) by undoing the screw and refit it on the opposite side. 10 H 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 4 3 8mm D164 2 5 1 D415 14 USE Operation - regulating the temperature Turn the thermostat dial, positioned at the top right of the compartment, clockwise to the required position (beyond the «O» position); the most suitable setting is between 2 and 4. [. . . ] If the compartment is full and the failure does not last long, the food will not be affected; otherwise, you are advised to consume it soon after. Defrosting The refrigerating compartment evaporator is automatically defrosted every time the compressor stops. 12) and is collected in a container at the back above the compressor where it evaporates. In the compartment, the frost must be removed whenever a thick layer accumulates (approx. Do not use metal tools to remove the frost ­ they can cause serious damage. [. . . ]