User manual KENWOOD DPF-1010

[. . . ] CD PLAYER DPF-1010 DPF-2010 DPF-3010 INSTRUCTION MANUAL KENWOOD CORPORATION COMPACT DIGITAL AUDIO B60-3730-08 00 KO ( T, M, X ) OC 99/12 11 10 9 8 7 6 5 4 3 2 1 98/12 11 10 9 8 7 6 5 4 3 Introduction DPF-3010/2010/1010 (En) Before applying power 2 Units are designed for operation as follows. Caution : Read this section carefully to ensure safe operation. Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120 / 220-240 V switchable *AC voltage selection The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped. Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction. AC voltage selector switch AC 110­ 120V Note: Our warranty does not cover damage caused by excessive line voltage due to improper setting of the AC voltage selector switch. AC 220­ 240V Move switch lever to match your line voltage with a small screwdriver or other pointed tool. For the United Kingdom Factory fitted moulded mains plug 1. [. . . ] If your equipment consists of this kind of combination, please do not connect any system control cords. Even without system control cords, normal operations can be carried out without affecting performance. If your amp or receiver does not have a system control terminal, do not connect any system control cords to the system control terminals on the other components. Do not connect system control cords to any components other than those specified by Kenwood. Be sure the system control plugs are inserted all the way in to the system control terminals. j SYSREM CONTROL selector switch SYSTEM CONTROL Notes SYSTEM CONTROL OPERATIONS Remote Control Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver. Automatic Operation (Except [XR] equipment) Automatically switches the input selector on the amplifier or receiver when you start playback from this unit. Synchronized Recording (Except [XR] equipment) Lets you synchronize recording with the start of playback when recording from CD. Also, the simple CCRS operation lets you make great recordings from CD. See the operating instructions supplied with your cassette deck and MD recorder for details. Maintenance DPF-3010/2010/1010 (En) Disc handling precautions Cleaning Handling Hold compact discs so that you do not touch the playing surface. If fingerprints or foreign matter become attached to the disc, lightly wipe the disc with a soft cotton cloth (or similar) from the center of the disc outwards, in a radial manner. 9 Label side Playing side Sticker Sticky paste ÷ Do not attach paper or tape to either the playing side or the label side of compact discs. ÷ The paste left on the label surface after a sticker has been peeled off is a factor which may cause malfunction. If the surface is sticky due to remaining paste, be sure to clean it with alcohole before use. Storage When a disc is not to be played for a long period of time, remove it from the CD player and store it in its case. Caution on disc used Never play a cracked or warped disc. During playback, the disc rotates at high speed in the player. Therefore, to avoid danger, never use a cracked or deformed disc or a disc repaired with tape or adhesive agent. Do not use cleaning discs. Please do not use commercially available cleaning discs, they may damage the internal mechanism. Discs which can be played with this unit CD (12 cm, 8 cm), CDV (only the audio part) ÷ With CD-G (CD Graphics) discs, this unit can play only the audio. Cleaning Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Be specially careful against contact cleaners containing oil, for they may deform the plastic components. Note related to transportation and movement Before transporting or moving this unit, carry out the following operations. Verify that the display shown appears. TRACK no CD accessories The CD accessories (stebilizer, protection sheet, protection ring, etc. ) which are marketed for improving the sound quality or protecting discs as well as the disc cleaner should not be used with this system because they may cause malfunction. d1 SC 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 3. Wait a few seconds and set the unit to STANDBY mode. Caution on condensation Condensation (of dew) may occur inside the unit when there is a great difference in temperature between this unit and the outside. In this case, leave the unit for a few hours with the power left ON, and restart the operation after the condensation has dried up. Be specially cautious against condensation in a following circumstance: When this unit is carried from a place to another across a large difference in temperature, when the humidity in the room where this unit is installed increases, etc. Controls and indicators DPF-3010/2010/1010 (En) 10 REPEAT indicator CCRS indicator EDIT indicator SINGLE TIME indicator TOTAL TIME indicator Program check indicator TRACK PGM REPEAT TRACK NO. CCRS EDIT P. C. SINGLE TOTAL TIME TIME TRACK mode indicator Program mode indicator 88 _8 8 : 8 8 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Pause indicator Play indicator The figure shows an example for the DPF-3010 Play track No. Output level indicator Music calender DISPLAY 1 2 34 5 6 78 STOP PLAY/PAUSE 6 0 ON/STANDBY 1 4 7 EDIT CLEAR TIME DISPLAY 0 2 5 8 3 7 4 P. MODE CHECK PEAK SEARCH 6 ¢ ¡ RANDOM 1 9 REPEAT PHONES +10 9 0 !@ # $ % ^ & * The keys with the same name as those on the remote control unit operate the same way as the remote control unit. 1 ON/STANDBY ( 2P . MODE key ) switch @ $ %( ( @ @ @ # 7 0 EDIT key Press to select the edit recording mode. * %( # !CLEAR key Press to clear the contents of a program. 3 CHECK key Press to display the programmed contents in order. @ TIME DISPLAY key Press to switch the time display mode. 4 PEAK SEARCH key 5 Open/Close key (0) Opens and closes the disc tray. # Remote control light sensor (DPF-3010/2010 only) $ Disc tray Load the disc to be played back. 6 STOP key (7) 7 PLAY/PAUSE key (6) Each time the key is pressed, playback and pause switch each other. % Numeric keys Use the numeric keys to select the desired track. ^ REPEAT key Press to start repeated playback. & RANDOM key Press to start random playback. * Search keys (1, ¡) Fast forwards or fast reverses the track. 8 Skip keys (4, ¢) Press to skip to the beginning of another track. 9 PHONES jack (DPF-3010 only) Use to connect (optional) headphones. Operation of remote control unit (DPF-3010/DPF-2010 only) DPF-3010/2010/1010 (En) The keys with the same name as those on the main unit operate the same way as the main unit. 1 Program-related and other keys ) RANDOM key REPEAT key ^ P . MODE key $ TIME DISPLAY key # EDIT key * CHECK key %( CLEAR key %( *2 OUTPUT (DOWN, UP) key 3 Numeric keys ( 1 ~ ) , 0 ) 4 Basic function keys Skip keys (4, ¢) Search keys (1, ¡) Stop key (7) Play/Pause key (6) 7 # 11 RANDOM 1 DISC SELECTOR 2 3 REPEAT 4 5 DISC SKIP 1 P. MODE 1 2 3 TIME DISPLAY 4 5 6 EDIT 7 8 9 3 CHECK 0 +10 # # @ @ CLEAR 7 6 4 OUTPUT DOWN UP ¢ ¡ 4 2 1 REMOTE CONTROL UNIT RC-P0305 Model: RC-P0305 Infrared ray system Loading batteries 1 Remove the cover. 3 Close the cover. 2 1 2 1 ÷ Insert two AA-size (R6) batteries as indicated by the polarity marking. Operation After plugging in the power cord, press the ON/STANDBY ) switch of the main unit to turn the unit ON. When the ( unit is turned ON, press the key of the function to be operated. Remote control light sensor 6m 30 30 ÷ When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys. REMOTE CONTROL UNIT Operating range (Approx. ) RC-P0305 Notes 1. [. . . ] 1 Bit Oversampling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 fs (352. 8 kHz) [ Audio ] (for DPF-3010) Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Hz ~ 20 kHz, ±0. 5 dB Signal to noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . More than 100 dB Dynamic range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]